Home › Engine / Hybrid System › CRUISE CONTROL › MILLIMETER WAVE RADAR SENSOR › from 2020.08
RM27T0E _51 Engine / Hybrid System _053696 CRUISE CONTROL _0260751 MILLIMETER WAVE RADAR SENSOR A

CRUISE CONTROL  MILLIMETER WAVE RADAR SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:
·

If the millimeter wave radar sensor assembly has been struck or dropped, replace the millimeter wave radar sensor assembly with a new one.

·

When the front bumper assembly, radiator grille, millimeter wave radar sensor assembly or No. 1 millimeter wave radar sensor bracket is replaced, check that the position of the manual axis switching mechanism is within the standard value.



PROCEDURE

Hide 88211B 1.INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY

a.
B587691C05
3.167,0.781 3.333,0.938 0.167,0.156 10 true 1 0.323,0.74 0.479,0.885 0.156,0.146 10 true 2 1.635,0.208 1.781,0.365 0.146,0.156 10 true 3
V100135

Screw
V100136

Bolt


Attach the 2 guides.


b.

Temporarily install the millimeter wave radar sensor assembly with the 2 bolts and screw.


c.

Tighten the 2 bolts and screw in the order shown in the illustration.

Torque:
Bolt : 2.5 N*m (25 kgf*cm, 22 in.*lbf)


d.

Connect the connector.


Hide 53292A 2.INSTALL UPPER RADIATOR SUPPORT SEAL

Hide 88211B 3.ADJUST MILLIMETER WAVE RADAR SENSOR ASSEMBLY

a.

When the millimeter wave radar sensor assembly is replaced, adjust the millimeter wave radar sensor assembly.

Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT