Home › Audio / Visual / Telematics › AUDIO / VIDEO › QUARTER TRIM SPEAKER (for 3 Door) › from 2020.08
RM27T0E _56 Audio / Visual / Telematics _053720 AUDIO / VIDEO _0260984 QUARTER TRIM SPEAKER(for 3 Door) A

AUDIO / VIDEO  QUARTER TRIM SPEAKER(for 3 Door)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 86163 1.INSTALL NO. 2 SPEAKER BRACKET

a.

Align the positioning pin of the speaker bracket with the hole and temporarily install the bracket.


b.

Install the No. 2 speaker bracket with the 3 bolts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)

NOTICE:

Do not touch the cone of the speaker.



c.

Attach the clamp.


Hide 86160C 2.INSTALL REAR SPEAKER SET

a.

Temporarily install the speaker by attaching the 2 claws of the speaker to the door panel.


b.

Install the speaker with the 3 screws.

NOTICE:

Do not touch the cone of the speaker.



c.

Connect the connector.


Hide 64740C 3.INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH

Hide 73233 4.INSTALL OUTER LAP BELT ANCHOR COVER

Hide 62596D 5.INSTALL QUARTER TRIM POCKET TRAY

Hide 64712F 6.INSTALL FRONT DECK SIDE TRIM COVER (w/ Tonneau Cover)

Hide 64937A 7.INSTALL NO. 1 TONNEAU COVER HOLDER CAP (w/o Tonneau Cover)

Hide 64725D 8.INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK

Hide 58570C 9.INSTALL REAR FLOOR CARPET ASSEMBLY

Hide 62538E 10.INSTALL QUARTER TRIM COVER HOLE LH

Hide 58574A 11.INSTALL REAR FLOOR MAT REAR SUPPORT PLATE

Hide 64910M 13.INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

Hide 62312B 14.INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH

Hide 67920 15.INSTALL DOOR SCUFF PLATE ASSEMBLY LH

Hide 16.INSTALL REAR NO. 1 SEAT ASSEMBLY

Hide 17.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 18. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART