Home › Vehicle Interior › DOOR LOCK › REAR DOOR LOCK › from 2020.08
RM27T0E _58 Vehicle Interior _053730 DOOR LOCK _0261041 REAR DOOR LOCK A

DOOR LOCK  REAR DOOR LOCK  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 69780B 1.INSTALL REAR DOOR INSIDE LOCKING CABLE ASSEMBLY LH

Hide 69740D 2.INSTALL REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH

Hide 69340 3.INSTALL REAR DOOR LOCK ASSEMBLY LH

NOTICE:
·

When reusing the removed rear door lock assembly, replace the door lock wiring harness seal on the connector with a new one.

·

Do not allow grease or dust to adhere to the surface of the connector which contacts the door lock wiring harness seal.

·

Reusing the door lock wiring harness seal or using a damaged door lock wiring harness seal may allow water into the connection. This may result in a malfunction of the rear door lock assembly.



a.
B237877C01
0.063,0.083 0.417,0.354 0.354,0.271 12 false *A 0.083,2.229 0.438,2.5 0.354,0.271 12 false *B
*A w/o Double Locking System
*B w/ Double Locking System
V100135

Slide


Apply MP grease to the sliding parts of the rear door lock assembly.


b.

Install a new door lock wiring harness seal to the rear door lock assembly.


c.

Insert the rear door lock assembly into the rear door outside handle release plate, and set it on the rear door panel.


d.

Check that the rear door outside handle frame release plate is securely connected to the rear door lock assembly.


e.

Using a T30 "TORX" wrench, install the rear door lock assembly with the 3 screws.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


Hide 68104 4.INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH

Hide 68124B 5.INSTALL REAR DOOR QUARTER WINDOW GLASS LH

Hide 67408E 6.INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH

Hide 68152C 7.INSTALL REAR DOOR GLASS RUN LH

Hide 67842E 8.INSTALL REAR DOOR SERVICE HOLE COVER LH

Hide 68174A 9.INSTALL REAR DOOR INNER GLASS WEATHERSTRIP LH

Hide 67604 10.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 74611C 11.INSTALL ASSIST GRIP COVER LH

Hide 69298C 12.INSTALL NO. 2 DOOR INSIDE HANDLE BEZEL LH

Hide 13.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 14. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART