Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1. PRECAUTION
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
28800
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
63310
3.REMOVE ROOF HEADLINING ASSEMBLY
for 5 Door:
Remove the roof headlining assembly (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for 5 Door)>REMOVAL).
for 3 Door:
Remove the roof headlining assembly (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for 3 Door)>REMOVAL).
87217E
4.REMOVE NO. 2 AIR DUCT REAR SIDE (w/ Rear Cooler)
87217D
5.REMOVE NO. 1 AIR DUCT REAR SIDE (w/ Rear Cooler)
66425A
6.REMOVE REAR NO. 2 SIDE RAIL SPACER LH (for 3 Door)
62180A
7.REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH (w/o Rear No. 2 Seat)
Disconnect the connector.
When handling the airbag connector, take care not to damage the airbag wire harness.
Remove the 13 bolts and curtain shield airbag.
62180A
8.REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH (w/ Rear No. 2 Seat)
Disconnect the connector.
When handling the airbag connector, take care not to damage the airbag wire harness.
Remove the 17 bolts and curtain shield airbag.
62180A
9.REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH (for 3 Door)
Disconnect the connector.
When handling the airbag connector, take care not to damage the airbag wire harness.
Remove the 11 bolts and curtain shield airbag.