Before beginning this procedure, make sure that the rear air conditioning FOOT mode functions are not operating.
53292A
1.REMOVE UPPER RADIATOR SUPPORT SEAL
2.RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
for HFC-134a (R134a):
Click hereVehicle Interior>HEATING / AIR CONDITIONING>REFRIGERANT (for HFC-134a(R134a))>REPLACEMENT
for HFO-1234yf (R1234yf):
Click hereVehicle Interior>HEATING / AIR CONDITIONING>REFRIGERANT(for HFO-1234yf(R1234yf))>REPLACEMENT
3.DRAIN ENGINE COOLANT
for 1GR-FE:
Click hereEngine / Hybrid System>1GR-FE (COOLING)>COOLANT>REPLACEMENT
for 2TR-FE:
Click hereEngine / Hybrid System>2TR-FE (COOLING)>COOLANT>REPLACEMENT
for 5L-E:
Click hereEngine / Hybrid System>5L-E (COOLING)>COOLANT>REPLACEMENT
for 1GD-FTV:
Click hereEngine / Hybrid System>1GD-FTV (COOLING)>COOLANT>REPLACEMENT
4. PRECAUTION
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
5.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
6.REMOVE REAR NO. 2 SEAT ASSEMBLY
for Manual Seat:
Click hereVehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY (for Manual Seat Type LH Side)>REMOVAL
for Power Seat:
Click hereVehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY (for Power Seat Type LH Side)>REMOVAL
for Face to Face Seat Type:
Click hereVehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY(for Face to Face Seat Type)>REMOVAL
7.REMOVE REAR NO. 1 SEATBACK ASSEMBLY
for 60/40 Split Double-folding Seat Type LH Side:
for 60/40 Split Double-folding Seat Type RH Side:
58371F
8.REMOVE REAR NO. 1 FLOOR STEP COVER (w/ Rear No. 2 Seat)
67933
9.REMOVE INSIDE QUARTER SCUFF PLATE RH (w/ Rear No. 2 Seat)
67917C
10.REMOVE REAR DOOR SCUFF PLATE RH
62331C
11.REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH
73233
12.REMOVE OUTER LAP BELT ANCHOR COVER
64910M
13.REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
64717A
14.REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER (w/o Rear No. 2 Seat)
58401A
15.REMOVE NO. 1 DECK BOARD SUB-ASSEMBLY (w/o Rear No. 2 Seat)
58574A
16.REMOVE REAR FLOOR MAT REAR SUPPORT PLATE (w/o Rear No. 2 Seat)
57412C
17.REMOVE FLOOR SIDE RAIL LH (w/ Deck Rail)
57411D
18.REMOVE FLOOR SIDE RAIL RH (w/ Deck Rail)
58570C
19.REMOVE REAR FLOOR CARPET ASSEMBLY (w/o Rear No. 2 Seat)
73233A
20.REMOVE REAR NO. 1 SEAT OUTER LAP BELT ANCHOR COVER
64725D
21.REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK (w/o Rear No. 2 Seat)
64937A
22.REMOVE NO. 1 TONNEAU COVER HOLDER CAP (w/o Tonneau Cover)
64712F
23.REMOVE FRONT DECK SIDE TRIM COVER RH (w/ Tonneau Cover)
74617A
24.REMOVE ASSIST GRIP PLUG (w/ Rear No. 2 Seat)
74603C
25.REMOVE ASSIST GRIP SUB-ASSEMBLY (w/ Rear No. 2 Seat)
64730B
26.REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH
62630P
27.REMOVE REAR QUARTER TRIM PANEL ASSEMBLY RH
88710A
28.DISCONNECT AIR CONDITIONING TUBE AND ACCESSORY ASSEMBLY
Remove the bolt.
Disconnect the air conditioning tube and accessory assembly.
Do not use a screwdriver or similar tool to disconnect the tube.
Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.
Remove the 2 O-rings from the air conditioning tube and accessory assembly.
Using pliers, grip the claws of the clips and slide the 2 clips.
Disconnect the heater water inlet hose and heater water outlet hose.
87217E
29.REMOVE REAR SIDE NO. 2 AIR DUCT
Detach the 2 clips.
Detach the clamp and remove the rear side No. 2 air duct.
87217F
30.REMOVE REAR SIDE NO. 3 AIR DUCT
Detach the 2 clips and remove the rear side No. 3 air duct.
87217D
31.REMOVE REAR SIDE NO. 1 AIR DUCT
Detach the 2 claws and remove the cooler plate.
Swing the bottom of the rear side No. 1 air duct sideways and remove the rear side No. 1 air duct.
87030A
32.REMOVE REAR COOLING UNIT ASSEMBLY
Disconnect the 3 connectors and detach the 3 clamps.
Remove the 5 bolts and rear cooling unit assembly.
62170A
33.REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY RH
Use the same procedure as for the curtain shield airbag assembly LH.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>CURTAIN SHIELD AIRBAG ASSEMBLY>REMOVAL
88566V
34.REMOVE REAR ROOF NO. 5 AIR DUCT
Detach the clip and remove the rear roof No. 5 air duct.
88566U
35.REMOVE REAR ROOF NO. 4 AIR DUCT
Detach the clip and remove the rear roof No. 4 air duct.
88566T
36.REMOVE REAR ROOF NO. 3 AIR DUCT
Detach the clip and remove the rear roof No. 3 air duct.
88566S
37.REMOVE REAR ROOF NO. 2 AIR DUCT
Detach the clip and remove the rear roof No. 2 air duct.
88566R
38.REMOVE REAR ROOF NO. 1 AIR DUCT
Detach the 4 clips and remove the duct.