Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).
73200A
1.INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY
Align the claw with the anchor plate positioning hole, and install the front shoulder belt anchor adjuster assembly with the 2 bolts.
First install the lower bolt, and then install the upper bolt.
73220
2.INSTALL FRONT SEAT OUTER BELT ASSEMBLY LH
When installing the retractor, make sure the 2 claws of the vehicle (labeled "a" in the illustration) only contact the installation areas of the retractor.
Align the seat belt retractor positioning holes with the 2 claws of the vehicle.
Install the front seat outer belt assembly LH with the bolt.
Connect the pretensioner connector as shown in the illustration.
Install the shoulder anchor of the front seat outer belt assembly LH with the nut.
62520P
3.INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY LH
64740C
4.INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH
Attach the 9 claws and 12 clips to install the deck trim side panel assembly LH.
Install the 3 bolts and 2 screws.
Install the floor anchor of the rear No. 1 seat outer belt assembly LH with the bolt.
Install the floor anchor of the front seat outer belt assembly LHwith the bolt.
73233
5.INSTALL OUTER LAP BELT ANCHOR COVER
64712F
6.INSTALL FRONT DECK SIDE TRIM COVER (w/ Tonneau Cover)
64937A
7.INSTALL NO. 1 TONNEAU COVER HOLDER CAP (w/ o Tonneau Cover)
64725D
8.INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
58570C
9.INSTALL REAR FLOOR CARPET ASSEMBLY
62538C
10.INSTALL QUARTER TRIM COVER HOLE LH
58574A
11.INSTALL REAR FLOOR MAT REAR SUPPORT PLATE
58649C
12.INSTALL MAT SET PLATE COVER
64910M
13.INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
62312B
14.INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH
67920
15.INSTALL DOOR SCUFF PLATE ASSEMBLY LH
16.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
17. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
18.CHECK SRS WARNING LIGHT