Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
85720C
1.INSTALL FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
The regulator arm must be below the intermediate position when installing the front power window regulator motor assembly LH.
Apply MP grease to the sliding and rotating areas of the regulator motor.
Using a T25 "TORX" socket wrench, install the front power window regulator motor assembly LH with the 3 screws.
A new front power window regulator motor assembly LH uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.
69802
2.INSTALL FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY LH
68102
3.INSTALL FRONT DOOR GLASS SUB-ASSEMBLY LH
67832
4.INSTALL FRONT DOOR SERVICE HOLE COVER LH
86160
5.INSTALL FRONT NO. 1 SPEAKER ASSEMBLY
68172A
6.INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP LH
67602
7.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
74611C
8.INSTALL ASSIST GRIP COVER LH
67492A
9.INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH
69298A
10.INSTALL NO. 2 DOOR INSIDE HANDLE BEZEL LH
11.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
12. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
13.INITIALIZE POWER WINDOW CONTROL SYSTEM
Initialize the power window control system (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION).