Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR DOOR WINDOW FRAME MOULDING › from 2020.08
RM27T0E _59 Vehicle Exterior _053749 EXTERIOR PANELS / TRIM _0261309 REAR DOOR WINDOW FRAME MOULDING A

EXTERIOR PANELS / TRIM  REAR DOOR WINDOW FRAME MOULDING  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.

·

When installing the window frame moulding, heat the vehicle body and window frame moulding using a heat light.



Standard:
Item Temperature
Vehicle Body 40 to 60°C (104 to 140°F)
Window Frame Moulding 20 to 30°C (68 to 86°F)


NOTICE:

Do not heat the vehicle body or window frame moulding excessively.


PROCEDURE

Hide 75762A 1.INSTALL REAR DOOR FRONT WINDOW FRAME MOULDING LH

a.

Clean the vehicle body surface.

i.

Using a heat light, heat the vehicle body surface.


ii.

Remove the double-sided tape from the vehicle body surface.


iii.

Wipe off any tape adhesive residue with cleaner.



b.

Install a new rear door front window frame moulding LH.

i.

Using a heat light, heat a new rear door front window frame moulding LH and the vehicle body surface.


ii.

Remove the peeling paper from the face of the rear door front window frame moulding LH.

HINT:

After removing the peeling paper, keep the exposed adhesive free from foreign matter.



iii.

Attach the clip and double-sided tape to install the rear door front window frame moulding LH.

HINT:

Press the rear door front window frame moulding LH firmly to install it.




c.

Install a new door window frame moulding clip.


Hide 67872 2.INSTALL REAR DOOR WEATHERSTRIP LH

a.

Attach the clip to install the upper part of the rear door weatherstrip LH.


Hide 75722A 3.INSTALL REAR DOOR BELT MOULDING LH

Hide 68104 4.INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH

Hide 68124B 5.INSTALL REAR DOOR QUARTER WINDOW GLASS LH

Hide 67408E 6.INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH

Hide 68152C 7.INSTALL REAR DOOR GLASS RUN LH

Hide 67842E 8.INSTALL REAR DOOR SERVICE HOLE COVER LH

Hide 68174A 9.INSTALL REAR DOOR INNER GLASS WEATHERSTRIP LH

Hide 67604 10.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 74611C 11.INSTALL ASSIST GRIP COVER LH

Hide 69298C 12.INSTALL NO. 2 DOOR INSIDE HANDLE BEZEL LH

Hide 13.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 14. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART