Home › Drivetrain › AC60F (AUTOMATIC TRANSMISSION / TRANSAXLE) › SHIFT PADDLE SWITCH › from 2020.08
RM27T0E _52 Drivetrain _053698 AC60F AUTOMATIC TRANSMISSION / TRANSAXLE _0433833 SHIFT PADDLE SWITCH A

AC60F AUTOMATIC TRANSMISSION / TRANSAXLE  SHIFT PADDLE SWITCH  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the transmission shift switch assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Correction of steering angle neutral point Multi-terrain monitor system (Click here)

CAUTION:
B473126

Be sure to read precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


HINT:

When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane departure alert system Drive the vehicle straight ahead at 40 km/h (25 mph) or more for 10 seconds or more. (Click here)
Pre-collision system
Lighting system (EXT) (for LED Headlight)
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)
Vehicle stability control system (for Hydraulic brake booster) Drive the vehicle straight ahead at 40 km/h (25 mph) or more for at least 10 seconds. (Click here)


PROCEDURE

Hide 45100 2.REMOVE STEERING WHEEL ASSEMBLY

Hide 84250A 3.REMOVE STEERING PAD SWITCH ASSEMBLY

Hide 84610F 4.REMOVE TRANSMISSION SHIFT SWITCH ASSEMBLY

a.
C440697

Remove the 2 screws and disconnect the 2 transmission shift switch assemblies.


b.
C440698

Disconnect the 3 guides and remove the No. 1 switch wire from the steering wheel assembly.


c.
C439015

Cut the 2 cable ties and disconnect the No. 1 switch wire and 2 transmission shift switch assemblies.


d.
C440875

Disconnect the 2 No. 1 switch wire connectors and remove the 2 transmission shift switch assemblies.