Home › Steering › STEERING COLUMN › STEERING WHEEL › from 2020.08
RM27T0E _55 Steering _053718 STEERING COLUMN _0260959 STEERING WHEEL A

STEERING COLUMN  STEERING WHEEL  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing the steering wheel (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1.PLACE FRONT WHEELS FACING STRAIGHT AHEAD

Hide 2. PRECAUTION

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 45116 5.REMOVE NO. 1 STEERING WHEEL ORNAMENT

a.
C349297

Remove the 2 screws.


b.

Detach the 2 claws and 2 guide pins, remove the No. 1 steering wheel ornament.


Hide 45117 6.REMOVE NO. 2 STEERING WHEEL ORNAMENT

HINT:

Refer to "Remove No. 1 Steering Wheel Ornament".


Hide 84250A 7.REMOVE STEERING PAD SWITCH ASSEMBLY (w/ Steering Pad Switch)

a.
C371145

Remove the 4 screws.


b.
C374272C09
0,0 0,0 false
V113147

Remove in this Direction (1)
V113148

Remove in this Direction (2)


While pushing the steering pad switch assembly in the direction shown by the arrow (1) in the illustration to disengage the claw, pull the steering pad switch assembly in the direction shown by the arrow (2) in the illustration to disengage the guide pin.


c.
C374273C08
0,0 0,0 false
V113147

Remove in this Direction (1)
V113148

Remove in this Direction (2)


While pushing the steering pad switch assembly in the direction shown by the arrow (1) in the illustration to disengage the claw, pull the steering pad switch assembly in the direction shown by the arrow (2) in the illustration to disengage the guide pin.


d.

Remove the part from the steering wheel sub-assembly.

HINT:

Use the same procedure for both sides.



Hide 84247A 8.REMOVE STEERING PAD SWITCH LH (w/ Steering Pad Switch)

HINT:

Refer to "Remove Steering Pad Switch Assembly".


Hide 84632 9.REMOVE CRUISE CONTROL MAIN SWITCH (w/ Cruise Control System)

Hide 84610F 10.REMOVE TRANSMISSION SHIFT SWITCH ASSEMBLY (w/ Shift Paddle Switch)

Hide 45100 11.REMOVE STEERING WHEEL ASSEMBLY

a.

Remove the steering wheel set nut.


b.
C384113N01
2.448,0.438 1.271,0.583 1.271,0.583 2.458,0.521 true 1.083,0.5 1.396,0.698 0.313,0.198 10 false *a 0.323,2.26 0.635,2.458 0.313,0.198 10 false *b 1.531,3.063 1.844,3.26 0.313,0.198 10 true *c

Put matchmarks on the steering wheel and main shaft.

Text in Illustration
*a Matchmark
*b Hold
*c Turn


c.

Using SST, remove the steering wheel assembly.

SST
09950-50013  (09951-05010, 09952-05010, 09953-05020, 09954-05011)


Hide 45713A 12.REMOVE STEERING SHAKE DAMPER (w/ Steering Shake Damper)

a.
C335455

Remove the 2 screws and remove the steering shake damper.


Hide 45184 13.REMOVE STEERING WHEEL BOSS LOWER COVER (w/o Steering Heater)

a.
C347267

Detach the 6 claws remove the steering wheel boss lower cover.