PROBLEM SYMPTOM CONFIRMATION
Based on the result of the customer problem analysis, try to reproduce the symptoms. If the problem is that the transmission does not shift up or down, or that the shift point is too high or too low, conduct the following road test referring to the automatic shift schedule and attempt to duplicate the problem symptoms.
ROAD TEST
Perform a road test.
Check for safety before performing any tests.
Be sure to inspect and adjust the engine before performing these tests.
Perform the road test with the engine coolant temperature is 70°C (158°F) or higher and the ATF temperature between 40 and 110°C (104 and 230°F).
Perform these tests with the air conditioning and cruise control off.
| Inspection | Procedure |
|---|---|
| Transmission Control Switch Test | With the vehicle stationary and the shift lever in D, move the shift lever to S and return it to D. Check that the meter display changes from D to the appropriate S range and then back again. |
| S Position Test | With the vehicle stationary and the shift lever in S, move the shift lever to "+" and "-". Check that the meter display changes between S ranges properly. |
| D Position Shift Test | While driving the vehicle normally, check that the transmission shifts up and down through each gear properly. |
| Lock-up Function | While driving on a level surface at a constant speed in the lock-up range with the shift lever in D, lightly depress the accelerator pedal and check that the engine speed does not change abruptly. |
| P Position Test | Stop the vehicle on an incline (approximately 5° or more). Then move the shift lever to P and release the parking brake. Check that the parking lock pawl holds the vehicle in place. |
| Abnormal Noise and Vibration | Check for abnormal noise and vibration while driving the vehicle forward and backward, and during shift operations. |
| Fluid Leakage | After performing all other road test inspections, check for fluid leakage. |
When checking for DTCs after a repair, drive the vehicle according to the monitor drive pattern (See page Drivetrain>AC60F (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSMISSION SYSTEM (for 1GR-FE)>MONITOR DRIVE PATTERN).
Gear change confirmation
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Data List / Vehicle Speed, Coolant Temp, SPD (NT), A/T Oil Temperature 1 and Shift Status.
Check that the transmission shifts to each gear while gently accelerating to 80 km/h (50 mph) or higher.
Check that the value of "SPD (NT)" drops by 50 rpm or more when the value of "Shift Status" increases.
Depending on the engine speed when the gear is changed, it may be difficult to see the change of "SPD (NT)".
Lock-up confirmation
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Data List / Vehicle Speed, Engine Speed, Coolant Temp, Accelerator Position, SPD (NT), A/T Oil Temperature 1, Lock Up and Shift Status.
When the following conditions are met, check that the difference between "Engine Speed" and "SPD (NT)" is 50 rpm or less.
| Accelerator Position | 6% |
| Vehicle Speed | 80 km/h (50 mph) or more |
| Shift Status | 6th gear |
| Lock Up | ON |
Lock-up prohibition conditions:
A/T oil temperature is below 40°C (104°F)
Engine coolant temperature is below 70°C (158°F)
Shift range between "1" (S1 range) and "3" (S3 range)
Accelerator pedal is fully released
Stop light switch signal is on