Home › Engine / Hybrid System › 1GD-FTV (LUBRICATION) › OIL PRESSURE SENSOR › from 2020.08
RM27T0E _51 Engine / Hybrid System _053690 1GD-FTV LUBRICATION _0436614 OIL PRESSURE SENSOR A

1GD-FTV LUBRICATION  OIL PRESSURE SENSOR  INSTALLATION  


PROCEDURE

Hide 83520 1.INSTALL OIL PRESSURE SENDER GAUGE ASSEMBLY

a.
A447373C01
1.698,0.49 1.875,0.49 1.875,0.49 2.052,1.063 false 1.51,0.385 1.698,0.594 0.188,0.208 10 false *a
*a Adhesive


Apply adhesive to 2 or 3 threads of the oil pressure sender gauge assembly.

Adhesive:

Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent


NOTICE:

Do not apply adhesive to the oil inlet port of the oil pressure sender gauge assembly.



b.

Using a 27 mm deep socket wrench, install the oil pressure sender gauge assembly to the oil filter bracket.

Torque:
15 N*m (153 kgf*cm, 11 ft.*lbf)

NOTICE:

Do not start the engine for at least 1 hour after the installation.



c.

Connect the oil pressure sender gauge connector.


Hide 51450 4.INSTALL REAR ENGINE UNDER COVER ASSEMBLY