Home › Engine / Hybrid System › CRUISE CONTROL › LANE DEPARTURE ALERT SYSTEM › from 2020.08
RM27T0E _51 Engine / Hybrid System _053696 CRUISE CONTROL _0332058 LANE DEPARTURE ALERT SYSTEM J

CRUISE CONTROL  LANE DEPARTURE ALERT SYSTEM  Indicator Circuit  


DESCRIPTION

The LDA indicator output request signal is sent from the forward recognition camera to the combination meter assembly via CAN communication.

CAUTION / NOTICE / HINT

NOTICE:

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in the combination meter assembly will not match the information from the vehicle, and may cause a DTC to be output.


PROCEDURE

1.READ VALUE USING GTS (CAN BUS CHECK)
a.

Using the GTS, perform CAN bus diagnostics and check that there are no malfunctions in ECUs connected to the CAN communication system.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (w/ Central Gateway ECU)>DIAGNOSIS SYSTEM


Result:
Result Proceed to
CAN communication system is normal (DTC (CAN Communication Malfunction, ECU Communication Malfunction/Communication Lost) is not output) A
CAN communication system is malfunctioning (DTC (CAN Communication Malfunction, ECU Communication Malfunction/Communication Lost) is output) B



A

2.CHECK FOR DTC (HEALTH CHECK)

B

2.CHECK FOR DTC (HEALTH CHECK)
a.

Using the GTS, perform a health check.


Result:
Result Proceed to
DTCs are not output. A
DTCs are output. B



A

3.PERFORM ACTIVE TEST USING GTS (METER DISPLAY)

B

GO TO DTC CHART FOR OUTPUT DTC

3.PERFORM ACTIVE TEST USING GTS (METER DISPLAY)
a.

Using the GTS, perform the Active Test.

Body Electrical > Combination Meter > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Meter Display 1 Multi-information display OFF or All -


Result:
Result Proceed to
The multi-information display in the combination meter assembly turns on according to the Active Test A
The multi-information display in the combination meter assembly does not turn off according to the Active Test B



A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

B

REPLACE COMBINATION METER ASSEMBLY