This is the audio and visual signal circuit from the HDMI terminal (connector cover) to the television display assembly.
Turn the ignition switch off.
Check that the connectors are properly connected to the television display assembly and HDMI terminal (connector cover).
Connectors are properly connected.
| Result | Proceed to |
|---|---|
| The connectors are properly connected | A |
| The connectors are not properly connected | B |
A
B
Disconnect the z24 antenna connector from the television display assembly.
Disconnect the Hz2 antenna connector from wire harness.
Measure the resistance according to the value (s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| z24-1 (TM2+) - Hz2-1 | Always | Below 1 Ω |
| z24-2 (TM2G) - Hz2-2 | Always | Below 1 Ω |
| z24-3 (TM2-) - Hz2-3 | Always | Below 1 Ω |
| z24-4 (TM1+) - Hz2-4 | Always | Below 1 Ω |
| z24-5 (TM1G) - Hz2-5 | Always | Below 1 Ω |
| z24-6 (TM1-) - Hz2-6 | Always | Below 1 Ω |
| z24-7 (TM0+) - Hz2-7 | Always | Below 1 Ω |
| z24-8 (TM0G) - Hz2-8 | Always | Below 1 Ω |
| z24-9 (TM0-) - Hz2-9 | Always | Below 1 Ω |
| z24-10 (TMC+) - Hz2-10 | Always | Below 1 Ω |
| z24-11 (TMCG) - Hz2-11 | Always | Below 1 Ω |
| z24-12 (TMC-) - Hz2-12 | Always | Below 1 Ω |
| z24-13 (CEC) - Hz2-13 | Always | Below 1 Ω |
| z24-15 (SCL) - Hz2-15 | Always | Below 1 Ω |
| z24-16 (SDA) - Hz2-16 | Always | Below 1 Ω |
| z24-17 (GND) - Hz2-17 | Always | Below 1 Ω |
| z24-18 (5V) - Hz2-18 | Always | Below 1 Ω |
| z24-19 (HPD) - Hz2-19 | Always | Below 1 Ω |
| z24-1 (TM2+) - Body ground | Always | 10 kΩ or higher |
| z24-2 (TM2G) - Body ground | Always | 10 kΩ or higher |
| z24-3 (TM2-) - Body ground | Always | 10 kΩ or higher |
| z24-4 (TM1+) - Body ground | Always | 10 kΩ or higher |
| z24-5 (TM1G) - Body ground | Always | 10 kΩ or higher |
| z24-6 (TM1-) - Body ground | Always | 10 kΩ or higher |
| z24-7 (TM0+) - Body ground | Always | 10 kΩ or higher |
| z24-8 (TM0G) - Body ground | Always | 10 kΩ or higher |
| z24-9 (TM0-) - Body ground | Always | 10 kΩ or higher |
| z24-10 (TMC+) - Body ground | Always | 10 kΩ or higher |
| z24-11 (TMCG) - Body ground | Always | 10 kΩ or higher |
| z24-12 (TMC-) - Body ground | Always | 10 kΩ or higher |
| z24-13 (CEC) - Body ground | Always | 10 kΩ or higher |
| z24-15 (SCL) - Body ground | Always | 10 kΩ or higher |
| z24-16 (SDA) - Body ground | Always | 10 kΩ or higher |
| z24-17 (GND) - Body ground | Always | 10 kΩ or higher |
| z24-18 (5V) - Body ground | Always | 10 kΩ or higher |
| z24-19 (HPD) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the Hz2 No. 2 antenna cord sub-assembly connector.
Disconnect the H100 console box wire (HDMI terminal) connector.
Measure the resistance according to the value (s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| Hz2-1 - H100-1 | Always | Below 1 Ω |
| Hz2-2 - H100-2 | Always | Below 1 Ω |
| Hz2-3 - H100-3 | Always | Below 1 Ω |
| Hz2-4 - H100-4 | Always | Below 1 Ω |
| Hz2-5 - H100-5 | Always | Below 1 Ω |
| Hz2-6 - H100-6 | Always | Below 1 Ω |
| Hz2-7 - H100-7 | Always | Below 1 Ω |
| Hz2-8 - H100-8 | Always | Below 1 Ω |
| Hz2-9 - H100-9 | Always | Below 1 Ω |
| Hz2-10 - H100-10 | Always | Below 1 Ω |
| Hz2-11 - H100-11 | Always | Below 1 Ω |
| Hz2-12 - H100-12 | Always | Below 1 Ω |
| Hz2-13 - H100-13 | Always | Below 1 Ω |
| Hz2-15 - H100-15 | Always | Below 1 Ω |
| Hz2-16 - H100-16 | Always | Below 1 Ω |
| Hz2-17 - H100-17 | Always | Below 1 Ω |
| Hz2-18 - H100-18 | Always | Below 1 Ω |
| Hz2-19 - H100-19 | Always | Below 1 Ω |
| Hz2-1 - Body ground | Always | 10 kΩ or higher |
| Hz2-2 - Body ground | Always | 10 kΩ or higher |
| Hz2-3 - Body ground | Always | 10 kΩ or higher |
| Hz2-4 - Body ground | Always | 10 kΩ or higher |
| Hz2-5 - Body ground | Always | 10 kΩ or higher |
| Hz2-6 - Body ground | Always | 10 kΩ or higher |
| Hz2-7 - Body ground | Always | 10 kΩ or higher |
| Hz2-8 - Body ground | Always | 10 kΩ or higher |
| Hz2-9 - Body ground | Always | 10 kΩ or higher |
| Hz2-10 - Body ground | Always | 10 kΩ or higher |
| Hz2-11 - Body ground | Always | 10 kΩ or higher |
| Hz2-12 - Body ground | Always | 10 kΩ or higher |
| Hz2-13 - Body ground | Always | 10 kΩ or higher |
| Hz2-15 - Body ground | Always | 10 kΩ or higher |
| Hz2-16 - Body ground | Always | 10 kΩ or higher |
| Hz2-17 - Body ground | Always | 10 kΩ or higher |
| Hz2-18 - Body ground | Always | 10 kΩ or higher |
| Hz2-19 - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the H100 console box wire (HDMI Terminal) from wire harness.
Measure the resistance according to the value (s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| HD-1 (TM2+) - H100-1 | Always | Below 1 Ω |
| HD-2 (TM2G) - H100-2 | Always | Below 1 Ω |
| HD-3 (TM2-) - H100-3 | Always | Below 1 Ω |
| HD-4 (TM1+) - H100-4 | Always | Below 1 Ω |
| HD-5 (TM1G) - H100-5 | Always | Below 1 Ω |
| HD-6 (TM1-) - H100-6 | Always | Below 1 Ω |
| HD-7 (TM0+) - H100-7 | Always | Below 1 Ω |
| HD-8 (TM0G) - H100-8 | Always | Below 1 Ω |
| HD-9 (TM0-) - H100-9 | Always | Below 1 Ω |
| HD-10 (TMC+) - H100-10 | Always | Below 1 Ω |
| HD-11 (TMCG) - H100-11 | Always | Below 1 Ω |
| HD-12 (TMC-) - H100-12 | Always | Below 1 Ω |
| HD-13 (CEC) - H100-13 | Always | Below 1 Ω |
| HD-15 (SCL) - H100-15 | Always | Below 1 Ω |
| HD-16 (SDA) - H100-16 | Always | Below 1 Ω |
| HD-17 (GND) - H100-17 | Always | Below 1 Ω |
| HD-18 (5V) - H100-18 | Always | Below 1 Ω |
| HD-19 (HPD) - H100-19 | Always | Below 1 Ω |
| HD-1 (TM2+) - Body ground | Always | 10 kΩ or higher |
| HD-2 (TM2G) - Body ground | Always | 10 kΩ or higher |
| HD-3 (TM2-) - Body ground | Always | 10 kΩ or higher |
| HD-4 (TM1+) - Body ground | Always | 10 kΩ or higher |
| HD-5 (TM1G) - Body ground | Always | 10 kΩ or higher |
| HD-6 (TM1-) - Body ground | Always | 10 kΩ or higher |
| HD-7 (TM0+) - Body ground | Always | 10 kΩ or higher |
| HD-8 (TM0G) - Body ground | Always | 10 kΩ or higher |
| HD-9 (TM0-) - Body ground | Always | 10 kΩ or higher |
| HD-10 (TMC+) - Body ground | Always | 10 kΩ or higher |
| HD-11 (TMCG) - Body ground | Always | 10 kΩ or higher |
| HD-12 (TMC-) - Body ground | Always | 10 kΩ or higher |
| HD-13 (CEC) - Body ground | Always | 10 kΩ or higher |
| HD-15 (SLC) - Body ground | Always | 10 kΩ or higher |
| HD-16 (SDA) - Body ground | Always | 10 kΩ or higher |
| HD-17 (GND) - Body ground | Always | 10 kΩ or higher |
| HD-18 (5V) - Body ground | Always | 10 kΩ or higher |
| HD-19 (HPD) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG