When the rear window defogger switch is turned on, a rear window defogger activation request signal is sent via the LIN communication line to the air conditioning amplifier.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Since the window defogger system has functions that use LIN communication, first confirm that there is no malfunction in the communication system by inspecting the LIN communication functions in accordance with the "How to Proceed with Troubleshooting" procedures. Then, conduct the following inspection procedure.
Using the GTS, perform the Active Test (See page Vehicle Exterior>WINDOW / GLASS>WINDOW DEFOGGER SYSTEM>DATA LIST / ACTIVE TEST).
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Defogger Relay (Rear) | Defogger relay (DEF) operation | OFF/ON | - |
The defogger relay (DEF) operates normally.
OK
NG
Temporarily replace the heater control with a new or normally functioning one (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING PANEL>REMOVAL).
Check the rear defogger function.
The window defogger function operates normally.
OK
NG
Remove the defogger relay (DEF) from the engine room relay block, junction block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 - 5 | Battery voltage applied between terminals 1 and 2 | Below 1 Ω |
| 3 - 5 | Battery voltage not applied between terminals 1 and 2 | 10 kΩ or higher |
OK
NG
| *a | Front view of wire harness connector
(to Defogger Relay [DEF]) |
Remove the defogger relay (DEF) from the engine room relay block, junction block.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| Defogger relay (DEF) terminal 2 - Body ground | Ignition switch off | Below 1 V |
| Defogger relay (DEF) terminal 2 - Body ground | Ignition switch ON | 11 to 14 V |
| Defogger relay (DEF) terminal 5 - Body ground | Always | 11 to 14 V |
OK
NG
Disconnect the G25 air conditioning amplifier connector.
Remove the defogger relay (DEF) from the engine room relay block, junction block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| Defogger relay (DEF) terminal 1 - G25-38 (RDEF) | Always | Below 1 Ω |
| G25-14 (GND) - Body ground | Always | Below 1 Ω |
| G25-38 (RDEF) - Body ground | Always | 10 kΩ or higher |
OK
NG
| *a | Component with harness connected
(Air Conditioning Amplifier Assembly) |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| G25-38 (RDEF) - G25-14 (GND) | Ignition switch ON, defogger switch on | 11 to 14 V |
| G25-38 (RDEF) - G25-14 (GND) | Ignition switch ON, defogger switch off | Below 1 V |
OK
NG
Disconnect the Y2*1 or X7*2 and X8*2 back door glass (window defogger wire) connectors.
*1: w/ Glass Hatch Opener System
*2: w/o Glass Hatch Opener System
Remove the defogger relay (DEF) and MIR HTR relay* from the engine room relay block, junction block.
*: for 5L-E
Remove the MIR HTR relay from the No. 8 relay block.*
*: except 5L-E, w/ Mirror Heater
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| Defogger relay (DEF) terminal 3 - Y2-2 | Always | Below 1 Ω |
| Y2-1 - Body ground | Always | Below 1 Ω |
| Y2-2 - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| Defogger relay (DEF) terminal 3 - X7-1 | Always | Below 1 Ω |
| X8-1 - Body ground | Always | Below 1 Ω |
| X7-1 - Body ground | Always | 10 kΩ or higher |
| Result | Proceed to |
|---|---|
| OK (w/ Glass Hatch Opener System) | A |
| OK (w/o Glass Hatch Opener System) | B |
| NG | C |
A
B
C