Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster) › from 2020.08
RM27T0E _54 Brake _053712 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0260911 VEHICLE STABILITY CONTROL SYSTEM(for Hydraulic Brake Booster) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM(for Hydraulic Brake Booster)  C1417  High Power Supply Voltage Malfunction  


DESCRIPTION

If a malfunction is detected in the power supply circuit, the skid control ECU (housed in the master cylinder solenoid) stores this DTC and the fail-safe function prohibits ABS/VSC/TRC operation.

This DTC is stored when the IG1 terminal voltage deviates from the DTC detection condition due to a malfunction in the power supply or charging circuit such as the battery or generator circuit, etc.

This DTC is cleared when the IG1 terminal voltage returns to normal.

DTC Code DTC Detection Condition Trouble Area
C1417 The IG1 terminal voltage is 17.4 V or higher for 0.8 seconds or more.
·

Charging system

·

Power source circuit

·

Internal power supply circuit of the skid control ECU



CAUTION / NOTICE / HINT

NOTICE:

When replacing the master cylinder solenoid, perform calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster)>CALIBRATION).


PROCEDURE

1.CHECK TERMINAL VOLTAGE (IG1)
a.

Disconnect the A7 skid control ECU connector.


U148396E03
2.646,1.563 2.646,1.865 false 0.125,0 2.552,0.354 2.427,0.354 10 false *a 2.521,1.896 2.802,2.073 0.281,0.177 10 false IG1 0.281,0.719 0.49,0.885 0.208,0.167 10 false A7

b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
A7-46 (IG1) - Body ground Ignition switch ON 10.5 to 16 V*1
11 to 14 V*2


*1: w/ Stop and Start System

*2: w/o Stop and Start System


Text in Illustration
*a Front view of wire harness connector
(to Skid Control ECU)

Result
Result Proceed to
OK A
NG (for 1GR-FE) B
NG (for 2TR-FE) C
NG (for 1GD-FTV) D



A

2.RECONFIRM DTC

B

C

D