Home › Engine / Hybrid System › 1GR-FE (ENGINE CONTROL) › SFI SYSTEM › from 2020.08
RM27T0E _51 Engine / Hybrid System _053657 1GR-FE ENGINE CONTROL _0260436 SFI SYSTEM L

1GR-FE ENGINE CONTROL  SFI SYSTEM  PRECAUTION  


DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


NOTICE:
·

After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When disconnecting and reconnecting the battery.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART





INITIALIZATION


NOTICE:
·

Perform Registration (VIN registration or frame number registration) when replacing the ECM (See page Engine / Hybrid System>1GR-FE (ENGINE CONTROL)>SFI SYSTEM>REGISTRATION).

·

If the ECM is replaced, register the ECM communication ID for the immobiliser system (refer to the Service Bulletin for Registration).

·

for Automatic Transmission

Perform initialization (throttle position) after replacing the throttle body with motor assembly or cleaning any throttle body components (See page Engine / Hybrid System>1GR-FE (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION).

·

for Manual Transmission:

-

Perform initialization (throttle position) after reconnecting the battery cable or replacing the ECM (See page Engine / Hybrid System>1GR-FE (ENGINE CONTROL)>THROTTLE BODY>INSTALLATION).

-

Perform initialization (throttle position) after replacing the throttle body with motor assembly or cleaning any throttle body components (See page Engine / Hybrid System>1GR-FE (ENGINE CONTROL)>THROTTLE BODY>INSTALLATION).




HINT:

Initialization cannot be completed only by disconnecting the cable from the battery terminal.



USING GTS


CAUTION:

Observe the following items for safety reasons:


·

Read the GTS's instruction books before using the GTS.

·

Make sure that the GTS cable is not caught on the pedals, shift lever or steering wheel when driving with the GTS connected to the vehicle.

·

When driving the vehicle for testing purposes using the GTS, two persons are required. One person drives the vehicle and the other operates the GTS.