Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
3.REMOVE REAR WHEEL
4.DRAIN BRAKE FLUID
47319F
5.DISCONNECT REAR FLEXIBLE HOSE LH
89546
6.REMOVE REAR SPEED SENSOR LH
7.REMOVE PARKING BRAKE ASSEMBLY
Remove the parking brake assembly (See page Brake>PARKING BRAKE>PARKING BRAKE ASSEMBLY>DISASSEMBLY).
42312
8.REMOVE REAR AXLE SHAFT WITH PARKING BRAKE PLATE LH
Remove the 4 nuts and rear axle shaft with parking brake plate.
Remove the O-ring.
42312C
9.REMOVE REAR AXLE SHAFT OIL SEAL LH
Using SST, remove the rear axle shaft oil seal.