When using a vise, do not overtighten it.
When installing the parts indicated by arrows, coat them with power steering fluid (See page Steering>POWER ASSIST SYSTEMS>VANE PUMP (for 1GR-FE)>COMPONENTS).
1. PRECAUTION
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
3.REMOVE FRONT WHEEL RH
53736
4.REMOVE FRONT FENDER APRON SEAL RH
11259
5.REMOVE V-BANK COVER SUB-ASSEMBLY
6.REMOVE AIR CLEANER CAP AND HOSE
17801
7.REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
8.REMOVE AIR CLEANER CASE
16361A
9.REMOVE FAN AND GENERATOR V BELT
10.DISCONNECT POWER STEERING OIL PRESSURE SWITCH CONNECTOR
Disconnect the 2 connectors.
44348A
11.DISCONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE
Slide the clip and disconnect the oil reservoir to pump hose from the vane pump.
44410
12.DISCONNECT PRESSURE FEED TUBE
Remove the union bolt and disconnect the pressure feed tube.
Remove the gasket.
44310
13.REMOVE VANE PUMP ASSEMBLY
Remove the bolt and harness bracket.
Remove the 2 bolts and vane pump.