The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the fuel pressure regulator assembly removal/installation are shown below.
When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
1.DISCHARGE FUEL SYSTEM PRESSURE
2. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
22030
4.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY
23273C
5.DISCONNECT NO. 2 FUEL HOSE
23280
6.REMOVE FUEL PRESSURE REGULATOR ASSEMBLY
Disconnect the purge VSV connector.
Detach the wire harness clamp.
Remove the bolt and disconnect the wire harness clamp bracket.
Remove the 3 bolts and fuel pressure regulator assembly.
Remove the O-ring from the fuel pressure regulator assembly.
| *a | O-ring |