This DTC is stored when the parking assist ECU receives a wheel speed sensor abnormality signal from the vehicle stability control system via CAN communication.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C164D | Wheel speed sensor malfunction. | Vehicle stability control system |
When "!" mark is displayed on the radio and display receiver assembly after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>MULTI-TERRAIN MONITOR SYSTEM>INITIALIZATION
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the multi-terrain monitor system may be needed.
(See page General>SETUP>WHEN REPLACING OR REMOVING/INSTALLING PARTS>WORK PROCEDURE)
The multi-terrain monitor system troubleshooting procedure is based on the premise that the vehicle stability control system is operating normally. Check the vehicle stability control system first before troubleshooting the multi-terrain monitor system.
for Vacuum Brake Booster
for Hydraulic Brake Booster
Clear the DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>MULTI-TERRAIN MONITOR SYSTEM>DTC CHECK / CLEAR).
Check for DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>MULTI-TERRAIN MONITOR SYSTEM>DTC CHECK / CLEAR).
DTC C164D is not output.
OK
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
NG
for Vacuum Brake Booster:
for Hydraulic Brake Booster: