Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › MULTI-TERRAIN MONITOR SYSTEM › from 2020.08
RM27T0E _56 Audio / Visual / Telematics _053722 PARK ASSIST / MONITORING _0328431 MULTI-TERRAIN MONITOR SYSTEM C

PARK ASSIST / MONITORING  MULTI-TERRAIN MONITOR SYSTEM  C1697  Camera Position Adjustment Incomplete  


DESCRIPTION

This DTC is stored when the parking assist ECU judges that the camera initial setting has not been memorized (camera view adjustment is incomplete).

DTC Code DTC Detection Condition Trouble Area
C1697 Camera initial setting has not been memorized
·

Camera view adjustment

·

Parking assist ECU



CAUTION / NOTICE / HINT

NOTICE:
·

When "!" mark is displayed on the radio and display receiver assembly after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point.

(See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>MULTI-TERRAIN MONITOR SYSTEM>INITIALIZATION)

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the multi-terrain monitor system may be needed (See page General>SETUP>WHEN REPLACING OR REMOVING/INSTALLING PARTS>WORK PROCEDURE).



PROCEDURE

1.ADJUST SETTINGS (CAMERA VIEW ADJUSTMENT)
a.

Perform the following procedure depending on the memory conditions to register the vehicle information to the parking assist ECU.




NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC

b.

Check for DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>MULTI-TERRAIN MONITOR SYSTEM>DTC CHECK / CLEAR).

OK:

DTC C1697 is not output.


HINT:
·

If DTC C1697 is output, perform the camera view adjustment again.

·

If DTC C1697 is still output after performing the camera view adjustment 3 times, replace the parking assist ECU.





OK

END (CAMERA VIEW ADJUSTMENT IS DEFECTIVE)

NG