28100
1.INSTALL STARTER ASSEMBLY
for Automatic Transmission:
Install the starter assembly with the 2 bolts.
for Manual Transmission:
Temporarily install the starter assembly with the bolt.
Temporarily install the clutch flexible hose bracket with the bolt.
| *1 | Clutch Flexible Hose Bracket |
Tighten the 2 bolts.
Connect the starter wire to terminal 30 with the nut.
Install the terminal cap.
Connect the starter connector.
31470
2.CONNECT CLUTCH RELEASE CYLINDER ASSEMBLY (for Manual Transmission)
51450
3.INSTALL REAR ENGINE UNDER COVER ASSEMBLY
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
5. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART