Home › Engine / Hybrid System › 1GR-FE (STARTING) › STARTER › from 2020.08
RM27T0E _51 Engine / Hybrid System _053692 1GR-FE STARTING _0260717 STARTER A

1GR-FE STARTING  STARTER  INSTALLATION  


PROCEDURE

Hide 11363A 1.INSTALL FLYWHEEL HOUSING SIDE COVER

Hide 28100 2.INSTALL STARTER ASSEMBLY

a.

Install the starter assembly with the 2 bolts.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)


b.

Connect the starter wire with the bolt and nut.

Torque:
for bolt : 8.0 N*m (82 kgf*cm, 71 in.*lbf)
for nut : 9.8 N*m (100 kgf*cm, 87 in.*lbf)


c.

Close the terminal cap.


d.

Connect the starter connector.


e.

Connect the ground wire with the bolt.

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)


Hide 28192 3.INSTALL STARTER COVER

a.

Install the starter cover with the 3 bolts.

Torque:
12 N*m (117 kgf*cm, 8 ft.*lbf)


Hide 17105 4.INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY LH

Hide 5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 6. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART