Home › Engine / Hybrid System › 5L-E (STARTING) › STARTER › from 2020.08
RM27T0E _51 Engine / Hybrid System _053693 5L-E STARTING _0260723 STARTER A

5L-E STARTING  STARTER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the starter assembly removal/installation are shown below.

Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Correction of steering angle neutral point Multi-terrain monitor system (Click here)

HINT:

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane departure alert system Drive the vehicle straight ahead at 40 km/h (25 mph) or more for 10 seconds or more. (Click here)
Pre-collision system
Lighting system (EXT) (for LED Headlight)
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)
Vehicle stability control system (for Hydraulic brake booster) Drive the vehicle straight ahead at 40 km/h (25 mph) or more for at least 10 seconds. (Click here)


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 51450 3.REMOVE REAR ENGINE UNDER COVER ASSEMBLY

Hide 31470 4.DISCONNECT CLUTCH RELEASE CYLINDER ASSEMBLY

Hide 31484 5.DISCONNECT CLUTCH FLEXIBLE HOSE BRACKET

a.
A225704

Remove the bolt and disconnect the clutch flexible hose bracket.


Hide 28100 6.REMOVE STARTER ASSEMBLY

a.
A224315

Disconnect the starter connector.


b.

Remove the terminal cap.


c.

Remove the nut and disconnect the starter wire.


d.
A224316

Remove the nut, 2 bolts and starter assembly.