Home › Power Source / Network › 1GD-FTV (BATTERY / CHARGING) › GENERATOR (for 130 A Type) › from 2020.08
RM27T0E _57 Power Source / Network _053727 1GD-FTV BATTERY / CHARGING _0261027 GENERATOR(for 130 A Type) A

1GD-FTV BATTERY / CHARGING  GENERATOR(for 130 A Type)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the generator assembly removal/installation are shown below.

Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Correction of steering angle neutral point Multi-terrain monitor system (Click here)

HINT:

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane departure alert system Drive the vehicle straight ahead at 40 km/h (25 mph) or more for 10 seconds or more. (Click here)
Pre-collision system
Lighting system (EXT) (for LED Headlight)
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)
Vehicle stability control system (for Hydraulic brake booster) Drive the vehicle straight ahead at 40 km/h (25 mph) or more for at least 10 seconds. (Click here)


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 74481 3.REMOVE BATTERY HOLD DOWN CLAMP

a.
A357172

Loosen the 2 nuts.


b.

Remove the 2 battery clamp bolts and battery hold down clamp.


Hide 28800 4.REMOVE BATTERY

Hide 74431 5.REMOVE BATTERY TRAY

Hide 12601B 6.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 17342F 7.REMOVE NO. 2 INTERCOOLER AIR HOSE (w/o Urea SCR System)

Hide 16361A 8.REMOVE FAN AND GENERATOR V BELT

Hide 27060 9.REMOVE GENERATOR ASSEMBLY

a.
A357173

Disconnect the connector from the generator assembly.


b.

Remove the terminal cap.


c.

Remove the nut and disconnect the wire harness from terminal B.


d.

Remove the bolt and disconnect the wire harness from the generator assembly.


e.

Detach the clamp and disconnect the wire harness from the generator bracket.


f.
A357174

Remove the 2 bolts and generator assembly.


g.
A357175

Remove the bolt and generator bracket from the generator assembly.