The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the generator assembly removal/installation are shown below.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
74481
3.REMOVE BATTERY HOLD DOWN CLAMP
Loosen the 2 nuts.
Remove the 2 battery clamp bolts and battery hold down clamp.
28800
4.REMOVE BATTERY
74431
5.REMOVE BATTERY TRAY
12601B
6.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
17342F
7.REMOVE NO. 2 INTERCOOLER AIR HOSE (w/o Urea SCR System)
16361A
8.REMOVE FAN AND GENERATOR V BELT
27060
9.REMOVE GENERATOR ASSEMBLY
Disconnect the connector from the generator assembly.
Remove the terminal cap.
Remove the nut and disconnect the wire harness from terminal B.
Remove the bolt and disconnect the wire harness from the generator assembly.
Detach the clamp and disconnect the wire harness from the generator bracket.
Remove the 2 bolts and generator assembly.
Remove the bolt and generator bracket from the generator assembly.