89837A
1.INSTALL REAR FLOOR SIDE AIRBAG SENSOR
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Install the rear floor airbag sensor with the bolt.
If the rear floor airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
When installing the rear floor airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
Check that the rear floor airbag sensor is not loose.
Connect the connector.
89839A
2.INSTALL REAR FLOOR SIDE AIRBAG SENSOR COVER
Attach the clip and claw to install the cover.
Return the floor carpet to its original position.
67918D
3.INSTALL REAR DOOR SCUFF PLATE LH
67917C
4.INSTALL REAR DOOR SCUFF PLATE RH
67934
5.INSTALL QUARTER SCUFF PLATE LH (w/ Rear No. 2 Seat)
67933
6.INSTALL QUARTER SCUFF PLATE RH (w/ Rear No. 2 Seat)
58371F
7.INSTALL REAR NO. 1 FLOOR STEP COVER (w/ Rear No. 2 Seat)
8.INSTALL REAR NO. 1 SEAT ASSEMBLY
for 60/40 Split Double-folding Seat Type LH Side:
Install the rear No. 1 seat assembly (See page Vehicle Interior>SEAT>REAR NO. 1 SEAT ASSEMBLY (for 60/40 Split Double-folding Seat Type LH Side)>INSTALLATION).
for 60/40 Split Double-folding Seat Type RH Side:
Install the rear No. 1 seat assembly (See page Vehicle Interior>SEAT>REAR NO. 1 SEAT ASSEMBLY (for 60/40 Split Double-folding Seat Type RH Side)>INSTALLATION).
for 60/40 Split Tumble Seat Type LH Side:
Install the rear No. 1 seat assembly (See page Vehicle Interior>SEAT>REAR NO. 1 SEAT ASSEMBLY(for 60/40 Split Tumble Seat Type LH Side)>INSTALLATION).
for 60/40 Split Tumble Seat Type RH Side:
Install the rear No. 1 seat assembly (See page Vehicle Interior>SEAT>REAR NO. 1 SEAT ASSEMBLY(for 60/40 Split Tumble Seat Type RH Side)>INSTALLATION).
for 60/40 Split Slide Walk-in Seat Type LH Side:
Install the rear No. 1 seat assembly (See page Vehicle Interior>SEAT>REAR NO. 1 SEAT ASSEMBLY (for 60/40 Split Slide Walk-in Seat Type LH Side)>INSTALLATION).
for 60/40 Split Slide Walk-in Seat Type RH Side:
Install the rear No. 1 seat assembly (See page Vehicle Interior>SEAT>REAR NO. 1 SEAT ASSEMBLY (for 60/40 Split Slide Walk-in Seat Type RH Side)>INSTALLATION).
9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
10. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
11.CHECK SRS WARNING LIGHT
Check the SRS warning light (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DIAGNOSIS SYSTEM).