Home › Suspension › SUSPENSION CONTROL › HEIGHT CONTROL DRYER › from 2020.08
RM27T0E _53 Suspension _053706 SUSPENSION CONTROL _0260874 HEIGHT CONTROL DRYER A

SUSPENSION CONTROL  HEIGHT CONTROL DRYER  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

Before removal, Be sure to disable vehicle height control by pressing the height control OFF switch and confirming that the height control OFF indication is displayed on the meter.


PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


NOTICE:

After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


Hide 3.REMOVE REAR WHEEL LH

Hide 76608 4.REMOVE REAR QUARTER PANEL MUDGUARD SUB-ASSEMBLY LH

Hide 48978 5.REMOVE HEIGHT CONTROL COMPRESSOR COVER

Hide 52046A 6.REMOVE REAR BUMPER PROTECTOR SUB-ASSEMBLY LH (for 5 Door)

Hide 48982 8.DISCONNECT NO. 2 HEIGHT CONTROL TUBE

Hide 48910B 9.REMOVE HEIGHT CONTROL COMPRESSOR ASSEMBLY

a.

Disconnect the connector.


b.
C213660

Detach the 3 clamps.


c.

Detach the No. 2 height control tube.


d.
C214821

Disconnect the connector.


e.

Detach the clamp.


f.
C213662

Remove the 3 bolts and height control compressor.


Hide 48950 10.REMOVE HEIGHT CONTROL DRYER ASSEMBLY

a.
C216435

Disconnect the No. 2 height control tube (See page Suspension>SUSPENSION CONTROL>SUSPENSION CONTROL SYSTEM (w/ Air Suspension)>PRECAUTION).

HINT:

For the disconnection procedure of the tube (type 2), refer to Precaution of the Suspension Control System section.



b.
C214816

Remove the bolt and height control dryer from the height control compressor.


c.

Remove the O-ring.