Home › Suspension › SUSPENSION CONTROL › REAR ACCELERATION SENSOR › from 2020.08
RM27T0E _53 Suspension _053706 SUSPENSION CONTROL _0260880 REAR ACCELERATION SENSOR A

SUSPENSION CONTROL  REAR ACCELERATION SENSOR  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


NOTICE:

After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


Hide 64740C 3.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

Hide 89190A 4.REMOVE REAR ACCELERATION SENSOR

a.
C213603

Disconnect the connector.


b.

Remove the bolt and rear acceleration sensor.

NOTICE:

Replace the rear acceleration sensor with a new one if it is dropped.