Home › Vehicle Interior › SEAT BELT › REAR NO. 1 SEAT INNER BELT ASSEMBLY (for 60/40 Split Slide Walk-in Seat Type LH Side) › from 2021.06
RM27T0E _58 Vehicle Interior _053738 SEAT BELT _0261157 REAR NO. 1 SEAT INNER BELT ASSEMBLY(for 60/40 Split Slide Walk-in Seat Type LH Side) A

SEAT BELT  REAR NO. 1 SEAT INNER BELT ASSEMBLY(for 60/40 Split Slide Walk-in Seat Type LH Side)  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.


HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.

·

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).



PROCEDURE

Hide 73390C 1.INSTALL REAR NO. 1 SEAT INNER BELT ASSEMBLY LH

B242874C05
0.469,2.667 0.344,2.021 0.344,2.021 0.24,2.021 true 2.833,0.719 3.063,0.792 3.063,0.792 3.063,1.635 true 2.99,1.646 3.188,1.854 0.198,0.208 10 true *a 0.083,1.938 0.281,2.146 0.198,0.208 10 false *a
*a Protruding Part


a.

Install the inner belt and connect the 3 point type belt anchor with the bolt.

Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)

NOTICE:

Do not allow the anchor part of the front seat inner belt assembly to overlap the protruding part of the front seat adjuster.



b.
B613932

w/ Seat Belt Warning System:

i.

Attach the clamp and connect the connector.



Hide 8.INSTALL REAR SEAT ASSEMBLY LH

Hide 9.CHECK SEAT BELT WARNING SYSTEM (w/ Seat Belt Warning System)