Home › Vehicle Interior › INTERIOR PANELS / TRIM › INSTRUMENT PANEL SAFETY PAD › from 2021.06
RM27T0E _58 Vehicle Interior _053741 INTERIOR PANELS / TRIM _0261213 INSTRUMENT PANEL SAFETY PAD A

INTERIOR PANELS / TRIM  INSTRUMENT PANEL SAFETY PAD  REASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 55538D 2.INSTALL SUNSHINE SENSOR HOLE COVER (w/o Automatic Light Control System)

a.

Attach the 2 claws to install the sunshine sensor hole cover.


Hide 89120 3.INSTALL AUTOMATIC LIGHT CONTROL SENSOR (w/ Automatic Light Control System)

Hide 89611 4.INSTALL ENGINE SWITCH (w/ Entry and Start System)

Hide 73960A 5.INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY

Hide 86101H 7.INSTALL ANTENNA CORD SUB-ASSEMBLY (w/ Navigation Antenna)

Hide 82142 8.INSTALL NO. 2 INSTRUMENT PANEL WIRE

a.

for LHD:

i.

Attach the 20 clamps to install the No. 2 instrument panel wire.


ii.

Connect the 2 connectors.



b.

for RHD:

i.

Attach the 20 clamps to install the No. 2 instrument panel wire.


ii.

Connect the 2 connectors.



Hide 55981 9.INSTALL NO. 1 DEFROSTER NOZZLE GARNISH

a.

Install the No. 1 defroster nozzle garnish with the 6 screws <A>.


Hide 55845A 10.INSTALL NO. 3 HEATER TO REGISTER DUCT

a.

Install the No. 3 heater to register duct with the 2 screws <A>.


Hide 55950G 11.INSTALL DEFROSTER NOZZLE ASSEMBLY

a.

Install the defroster nozzle assembly with the 4 screws <A>.


Hide 55971C 12.INSTALL NO. 1 SIDE DEFROSTER NOZZLE DUCT

a.

Attach the 2 claws to install the No. 1 side defroster nozzle duct.


b.

Install the screw <A>.


Hide 55972C 13.INSTALL NO. 2 SIDE DEFROSTER NOZZLE DUCT

HINT:

Use the same procedure described for the No. 1 side defroster nozzle duct.


Hide 55843A 14.INSTALL NO. 1 HEATER TO REGISTER DUCT

a.

Install the No. 1 heater to register duct with the 4 screws <A>.


Hide 55844 15.INSTALL NO. 2 HEATER TO REGISTER DUCT

HINT:

Use the same procedure described for the No. 1 heater to register duct.