Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
71706
1.REMOVE FRONT SEATBACK BOARD SUB-ASSEMBLY LH (w/ Seatback Board)
Detach the 2 hooks and disconnect the 2 rubber bands.
| *a | Protective Tape |
Apply protective tape to the locations shown in the illustration.
| *a | Protective Tape |
| *b | Point (A) |
Insert a screwdriver in the clearance between the front seatback board sub-assembly LH and separate type front seatback assembly.
Tape the screwdriver tip before use.
Place the screwdriver at point (A) shown in the illustration and move the screwdriver in the direction of the arrow to detach the 2 guides and remove the 2 front seatback board clips from the front seatback board sub-assembly LH.
Do not reuse the front seatback board clips after removing it.
Move the front seatback board sub-assembly LH in the direction of the arrow to detach the 2 guides and remove the front seatback board sub-assembly LH.
71706B
2.REMOVE FRONT SEATBACK BOARD CLIP (w/ Seatback Board)
Remove the 2 front seatback board clips from the separate type front seatback spring assembly.
84921B
3.REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB
Using a moulding remover, detach the 2 claws and remove the slide and vertical power seat switch knob.
84921A
4.REMOVE RECLINING POWER SEAT SWITCH KNOB
Using a moulding remover, detach the 2 claws and remove the reclining power seat switch knob.
71812D
5.REMOVE FRONT SEAT CUSHION SHIELD LH
Disconnect the lifter motor connector.
Remove the screw of the front seat No. 1 inner cushion shield LH and detach the guide.
Detach the clip of the front seat No. 1 inner cushion shield LH.
Using a moulding remover, detach the 3 claws and guide.
Move the front seat cushion shield LH in the direction of the arrow to detach the clip and remove the front seat No. 1 inner cushion shield LH together with the front seat cushion shield LH as a unit.
Detach the 3 claws and open the wire harness cover.
Detach the 3 wire harness clamps and disconnect the seat wire connector.
84922C
6.REMOVE FRONT POWER SEAT SWITCH LH
Remove the 3 screws.
w/ Seat Memory System:
Disconnect the 2 power seat switch connectors and remove the front power seat switch LH.
w/o Seat Memory System:
Disconnect the power seat switch connector and remove the front power seat switch LH.
84920
7.REMOVE LUMBAR SWITCH ASSEMBLY (for Driver Side)
71868A
8.REMOVE FRONT SEAT NO. 1 INNER CUSHION SHIELD LH
Detach the 2 claws and remove the front seat No. 1 inner cushion shield LH.
71862
9.REMOVE FRONT SEAT INNER CUSHION SHIELD LH
Using a moulding remover, detach the 3 claws and remove the front seat inner cushion shield LH.
71861
10.REMOVE FRONT SEAT INNER CUSHION SHIELD RH (for Front Passenger Side)
Using a moulding remover, detach the 4 claws and remove the front seat inner cushion shield RH.
73240
11.REMOVE FRONT SEAT INNER BELT ASSEMBLY LH
for Driver Side:
(See page Vehicle Interior>SEAT BELT>FRONT SEAT INNER BELT ASSEMBLY>REMOVAL)
for Front Passenger Side:
(See page Vehicle Interior>SEAT BELT>FRONT SEAT INNER BELT ASSEMBLY>REMOVAL)
12.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY
w/o Seatback Board:
Disconnect the rubber band.
Detach the clamp and disconnect the No. 2 seat wire.
w/ Seat Heater System:
Disconnect the seat heater connector and detach the seat heater wire harness clamp.
Detach the 2 hooks.
| *a | Fastening Tape |
| *b | Clamp |
| *c | Hook |
w/ Front Seat Side Airbag:
Detach the claw and disconnect the airbag connector.
Detach the 3 airbag wire harness clamps and hook.
Detach the fastening tape and open the cover.
Disconnect the airbag wire harness.
Remove the 4 bolts and seatback assembly.
71849
13.REMOVE SEAT ADJUSTER COVER CAP
Remove the 2 seat adjuster cover caps.
71149A
14.REMOVE FRONT SEAT LEG COVER LH
Detach the 2 claws.
Move the front seat leg cover LH in the direction of the arrow to remove it.
15.REMOVE SEAT CUSHION COVER WITH PAD
w/ Seat Heater System:
Disconnect the seat heater connector and detach the 3 seat heater wire harness clamps.
Detach the hooks.
for Front Passenger Side:
Detach the claw and disconnect the connector.
Remove the seat cushion cover with pad.
71072S
16.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER
Type A:
Remove the hog rings and disconnect the straps.
| *a | Tack Pin |
Type B:
Cut off the tack pins and disconnect the straps.
Remove the 15 hog rings and separate type front seat cushion cover from the separate type front seat cushion pad.
87510L
17.REMOVE FRONT SEAT CUSHION HEATER ASSEMBLY LH (w/ Seat Heater System)
71876
18.REMOVE RECLINING ADJUSTER INSIDE COVER LH
Detach the claw and guide, and then remove the reclining adjuster inside cover LH.
71874
19.REMOVE FRONT SEAT LOWER CUSHION SHIELD LH
Remove the screw.
Detach the hook and clip, and then remove the front seat lower cushion shield LH.
71873
20.REMOVE FRONT SEAT LOWER CUSHION SHIELD RH
Remove the screw.
Detach the hook and clip, and then remove the front seat lower cushion shield RH.
71537D
21.REMOVE FRONT SEAT CUSHION EDGE PROTECTOR LH
Remove the screw.
Move the front seat cushion edge protector LH in the direction of the arrow to detach the hook and remove the front seat cushion edge protector LH.
71537C
22.REMOVE FRONT SEAT CUSHION EDGE PROTECTOR RH
Use the same procedure described for the LH side.
85866A
23.REMOVE SEAT CUSHION CLIMATE CONTROL DUCT LH (w/ Climate Control Seat System)
Detach the 2 clamps and 2 claws, and then remove the seat cushion climate control duct LH.
85860B
24.REMOVE SEAT CUSHION CLIMATE CONTROL BLOWER ASSEMBLY LH (w/ Climate Control Seat System)
Remove the 2 screws and seat cushion climate control bracket.
Disconnect the connector.
Detach the 2 guides and remove the seat cushion climate control blower assembly LH as shown in the illustration.
87501B
25.REMOVE SEAT HEATER CONTROL SUB-ASSEMBLY LH (w/ Seat Heater System)
82192
26.REMOVE FRONT SEAT WIRE LH
Remove the seat wire LH.
71876A
27.REMOVE RECLINING ADJUSTER INSIDE COVER LH
Detach the guide and remove the reclining adjuster inside cover LH.
71875A
28.REMOVE RECLINING ADJUSTER INSIDE COVER RH
Detach the guide and remove the reclining adjuster inside cover RH.
71074S
29.REMOVE SEPARATE TYPE FRONT SEATBACK COVER
w/o Seatback Board:
Remove the 3 hog rings.
Open the 2 fasteners, and then open the seatback cover.
| *A | for Cloth Seat | *B | for Leather Seat |
w/ Seatback Board:
Detach the hooks.
Remove the 5 hog rings.
w/ Front Seat Side Airbag:
Remove the nut and seatback cover bracket from the seat frame.
| *A | for Type A | *B | for Type B |
Disconnect the seatback cover bracket from the separate type front seatback pad.
Using a screwdriver, detach the 4 claws and remove the 2 front seat headrest supports.
Remove the 13 hog rings and separate type front seatback cover.
87510N
30.REMOVE FRONT SEATBACK HEATER ASSEMBLY LH (w/ Seat Heater System)
71552S
31.REMOVE SEPARATE TYPE FRONT SEATBACK PAD
Remove the separate type front seatback pad.
85867A
32.REMOVE SEATBACK CLIMATE CONTROL BLOWER LH (w/ Climate Control Seat System)
Disconnect the connector.
Remove the 4 screws and seatback climate control blower LH.
85866C
33.REMOVE SEATBACK CLIMATE CONTROL DUCT LH (w/ Climate Control Seat System)
Detach the 2 claws and remove the seatback climate control duct LH.
82168
34.REMOVE NO. 2 SEAT WIRE
for Driver Side:
w/o Climate Control Seat System:
Disconnect the 2 connectors.
Detach the 2 clamps and remove the No. 2 seat wire.
for Driver Side:
w/ Climate Control Seat System:
Disconnect the 2 connectors.
Detach the 3 clamps and remove the No. 2 seat wire.
for Front Passenger Side:
Disconnect the connector.
Detach the 2 clamps and remove the seat wire.
35.REMOVE FRONT SEAT SIDE AIRBAG ASSEMBLY (w/ Front Seat Side Airbag)