Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT SEAT SIDE AIRBAG ASSEMBLY › from 2021.06
RM27T0E _58 Vehicle Interior _053735 SUPPLEMENTAL RESTRAINT SYSTEMS _0261096 FRONT SEAT SIDE AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT SEAT SIDE AIRBAG ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Be sure to read Precaution thoroughly before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).

·

Wear protective gloves. Sharp areas on the seat frame and adjuster may injure your hands.

·

If the side airbag was deployed, replace the front seat side airbag assembly, separate type front seatback spring assembly, separate type front seatback cover and separate type front seatback pad with the necessary parts in accordance with the extent of the collision damage.

for Manual Seat: (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>DISASSEMBLY)

for Power Seat: (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Power Seat)>DISASSEMBLY)

for Walk in Seat Type: (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Walk in Seat Type)>DISASSEMBLY)



HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.

·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side. (for Manual Seat, Power Seat)

·

The procedure listed below is for the RH side. (for Walk in Seat Type)



PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


NOTICE:

After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


Hide 71910A 3.REMOVE FRONT SEAT HEADREST ASSEMBLY

Hide 72128A 4.REMOVE FRONT SEAT INNER TRACK BRACKET COVER LH

Hide 72124 5.REMOVE FRONT SEAT OUTER TRACK BRACKET COVER LH

Hide 72158 6.REMOVE INNER SEAT TRACK BRACKET COVER LH

Hide 72138B 7.REMOVE SEAT TRACK COVER LH

Hide 72127A 8.REMOVE FRONT SEAT INNER TRACK BRACKET COVER RH (for Walk in Seat Type)

Hide 72123A 9.REMOVE FRONT SEAT OUTER TRACK BRACKET COVER RH (for Walk in Seat Type)

Hide 72157A 10.REMOVE INNER SEAT TRACK BRACKET COVER RH (for Walk in Seat Type)

Hide 72137B 11.REMOVE SEAT TRACK COVER RH (for Walk in Seat Type)

Hide 71706 13.REMOVE FRONT SEATBACK BOARD SUB-ASSEMBLY LH (w/ Seatback Board)

Hide 71706B 14.REMOVE FRONT SEATBACK BOARD CLIP (w/ Seatback Board)

Hide 73920A 15.DISCONNECT FRONT SEAT SIDE AIRBAG ASSEMBLY

a.

w/o Seatback Board:

i.
B239173

Remove the rubber band from the seat cushion spring.



b.

for Manual Seat, Power Seat:

i.
B615724C01
1.604,3.135 1.771,3.135 1.771,3.135 2.521,2.979 false 1.667,0.875 1.948,0.719 true 2.26,1.146 2.583,1.146 true 2.208,0.583 2.698,0.74 true 2.344,1.604 2.594,1.604 true 1.385,3.031 1.563,3.229 0.177,0.198 10 false *a 2.76,0.688 3.073,0.896 0.313,0.208 10 true *b 1.51,0.813 1.823,1.021 0.313,0.208 10 true *c 2.635,1.5 2.948,1.708 0.313,0.208 10 true *b 2.646,1.042 2.958,1.25 0.313,0.208 10 true *b
*a Fastening Tape
*b Airbag Wire Harness Clamp
*c Hook


Detach the claw and disconnect the airbag connector.


ii.

Detach the 3 airbag wire harness clamps and hook.


iii.

Detach the fastening tape and open the cover.


iv.

Disconnect the airbag wire harness.



c.

for Walk in Seat Type:

i.
B241196

Remove the rubber band from the seat cushion spring.


ii.
B241198C02
2.021,3.031 2.115,3.031 false 2.115,3.031 2.375,2.531 false 0.646,0.75 1.688,0.75 true 0.458,0.542 1.5,0.542 true 0.5,1.156 1.542,1.156 true 0.49,1.615 1.531,1.615 true 1.813,2.958 1.99,3.135 0.177,0.177 10 false *a 0.292,0.469 0.552,0.635 0.26,0.167 10 false *b 0.448,0.656 0.708,0.823 0.26,0.167 10 false *c 0.292,1.073 0.552,1.24 0.26,0.167 10 false *b 0.302,1.563 0.563,1.729 0.26,0.167 10 false *b
*a Fastening Tape
*b Airbag Wire Harness Clamp
*c Hook


Detach the claw and disconnect the airbag connector.


iii.

Detach the 3 airbag wire harness clamps and hook.


iv.

Detach the fastening tape and open the cover.


v.

Disconnect the airbag wire harness.



Hide 16.REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD

HINT:

Use the same procedure for the RH and LH sides.


a.
B241810

w/ Seat Heater System:

i.

Disconnect the seat heater connector and detach the wire harness clamp.



b.

w/o Seatback Board:

i.
B333273

Remove the 3 hog rings.


ii.

Open the 2 fasteners, and then open the front seatback cover.

B242232C05
0.896,0.042 1.177,0.292 0.281,0.25 12 false *A 4.385,0.052 4.667,0.292 0.281,0.24 12 false *B
*A for Cloth Seat *B for Leather Seat




c.

w/ Seatback Board:

i.
B357448

Detach the hooks.


ii.
B247933

Remove the 5 hog rings.



d.

Remove the nut and seatback cover bracket from the seat frame.

B617502C01
0.625,0.25 1,0.49 0.375,0.24 12 false *A 4.021,0.26 4.396,0.5 0.375,0.24 12 false *B
*A for Type A *B for Type B



e.

Disconnect the seatback cover bracket from the separate type front seatback pad.


f.
B239198

Using a screwdriver, detach the 4 claws to remove the 2 front seat headrest supports.


g.

Remove the separate type seatback cover with pad.


Hide 73920A 17.REMOVE FRONT SEAT SIDE AIRBAG ASSEMBLY

CAUTION:

When storing the front seat side airbag assembly, keep the airbag deployment side facing upward.


HINT:

Use the same procedure for the RH and LH sides.


a.

for Type A:

i.
B251815

Detach the 2 clamps.


ii.
B333276

Remove the 2 nuts and front seat side airbag assembly.

CAUTION:
·

The nuts must not be reused.

·

Make sure that the separate type front seatback spring assembly is not deformed. If it is, replace it with a new one.





b.

for Type B:

i.
B615142

Detach the clamp.


ii.
B615143

Remove the 2 nuts and front seat side airbag assembly.

CAUTION:
·

The nuts must not be reused.

·

Make sure that the separate type front seatback spring assembly is not deformed. If it is, replace it with a new one.