Home › Suspension › SUSPENSION CONTROL › KINETIC DYNAMIC SUSPENSION SYSTEM › from 2021.06
RM27T0E _53 Suspension _053706 SUSPENSION CONTROL _0260886 KINETIC DYNAMIC SUSPENSION SYSTEM C

SUSPENSION CONTROL  KINETIC DYNAMIC SUSPENSION SYSTEM  U0100  Lost Communication with ECM/PCM "A"  U0122  Lost Communication with Vehicle Dynamics Control Module  U0124  Lost Communication with Lateral Acceleration Sensor Module  U0126  Lost Communication with Steering Angle Sensor Module  


DESCRIPTION

DTC Code DTC Detection Condition Trouble Area
U0100 While driving at 19 mph (30 km/h), the ECM indicates a CAN communication stop for 3 seconds or more. CAN communication system
U0122 The skid control ECU indicates a CAN communication stop for 3 seconds or more. CAN communication system
U0124 The yaw rate and acceleration sensor indicates a CAN communication stop for 3 seconds or more. CAN communication system
U0126 The steering sensor indicates a CAN communication stop for 3 seconds or more. CAN communication system

PROCEDURE

1.CHECK DTC

b.

Perform a road test.


c.

Check for DTCs (See page Suspension>SUSPENSION CONTROL>KINETIC DYNAMIC SUSPENSION SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC is not output A
DTC is output B

HINT:

If a CAN communication malfunction DTC and a related sensor malfunction DTC are output at the same time, the CAN communication malfunction must be repaired before troubleshooting the sensor malfunction DTC.




A

B

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)