2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

HINT:
*: Use the GTS.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.CUSTOMER PROBLEM ANALYSIS
      NEXT

      3.CONNECT GTS TO DLC3

        HINT:
        If the display indicates a communication fault in the GTS, inspect the DLC3.
        When any CAN communication system DTCs are output, perform troubleshooting on the CAN communication system first.

      NEXT

      4.CHECK DTC AND FREEZE FRAME DATA*
      1. Check for DTCs (Click here) and freeze frame data (Click here).

      2. HINT:
        Record or print DTCs and freeze frame data, if necessary.

      NEXT

      5.CLEAR DTC AND FREEZE FRAME DATA*
      1. Clear DTCs and freeze frame data (Click here).

      NEXT

      6.CONDUCT VISUAL INSPECTION
        NEXT

        7.SET CHECK MODE DIAGNOSIS*
        1. Switch the ECM from normal mode to check mode.

        2. HINT:
          Refer to Check Mode Procedure (Click here).

        NEXT

        8.CONFIRM PROBLEM SYMPTOMS
        1. Confirm problem symptoms.

        2. HINT:
          1. Refer to Problem Symptoms Table (Click here).
          2. If the engine does not start, first perform the Check DTC procedures and Conduct Basic Inspection procedures below.

          Result 
          Result
          Proceed to
          Malfunction does not occur
          A
          Malfunction occurs
          B

        B.
        A

        9.SIMULATE SYMPTOMS

          HINT:
          Refer to Symptom Simulation (Click here).

        NEXT

        10.CHECK DTC*
        1. Check for DTCs.

        2. HINT:
          Refer to DTC Check / Clear (Click here).

          Result 
          Result
          Proceed to
          Trouble code output
          A
          No trouble code output
          B

        B.
        A

        11.REFER TO DTC CHART

          HINT:
          Refer to Diagnostic Trouble Code Chart (Click here).

        NEXT

        12.CONDUCT BASIC INSPECTION
        1. Conduct basic inspection (Click here).

        2. Result 
          Result
          Proceed to
          Malfunctioning parts not confirmed
          A
          Malfunctioning parts confirmed
          B

        B.
        A

        13.REFER TO PROBLEM SYMPTOMS TABLE

          HINT:
          Refer to Problem Symptoms Table (Click here).

          Result 
          Result
          Proceed to
          Malfunctioning circuit confirmed
          A
          Malfunctioning parts confirmed
          B

        B.
        A

        14.CHECK ECM POWER SOURCE CIRCUIT
        1. Check the ECM power source circuit.

        2. HINT:
          Refer to ECM Power Source Circuit (Click here).

        NEXT

        15.CONDUCT CIRCUIT INSPECTION
          Result 
          Result
          Proceed to
          Malfunction not confirmed
          A
          Malfunction confirmed
          B

        B.
        A

        16.CHECK FOR INTERMITTENT PROBLEMS
        1. Check for intermittent problems.

        2. HINT:
          Refer to Check for Intermittent Problems (Click here).

        NEXT

        17.CONDUCT PARTS INSPECTION
          NEXT

          18.IDENTIFY PROBLEM
            NEXT

            19.ADJUST AND/OR REPAIR
              NEXT

              20.CONDUCT CONFIRMATION TEST
                NEXT

                ← HOW TO PROCEED WITH TROUBLESHOOTING (Sep 2011 – Dec 2011)CHECK FOR INTERMITTENT PROBLEMS (Sep 2011 – Dec 2011) →