2011-2013 Land Cruiser · Service Manual Vehicle Exterior

Washer Signal Circuit

Circuit diagnosis · Vehicles built from Jan 2012

DESCRIPTION

The headlight cleaner control relay receives the windshield washer operation signal.

WIRING DIAGRAM

B246536E07

INSPECTION PROCEDURE


1. CHECK FRONT WIPER AND WASHER OPERATION
  1. Check the operation of the wiper and washer system (Click here).

    OK:
    Wiper and washer system operates normally.



NG
GO TO PROBLEM SYMPTOMS TABLE (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (WINDSHIELD WIPER SWITCH ASSEMBLY - HEADLIGHT CLEANER CONTROL RELAY)

  1. E139345E24
    Disconnect the headlight cleaner control relay connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    5 (FRWA) - Body ground
    Engine switch on (IG), front washer switch on
    Below 1 V
    5 (FRWA) - Body ground
    Engine switch on (IG), and front washer switch off
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← DATA LIST / ACTIVE TEST (from Jan 2012)Headlight Signal Circuit (from Jan 2012) →