2011-2013 Land Cruiser · Service Manual Vehicle Exterior

Headlight Signal Circuit

Circuit diagnosis · Vehicles built from Jan 2012

DESCRIPTION

The headlight cleaner control relay detects the low beam headlights status.

WIRING DIAGRAM

E247721E01

INSPECTION PROCEDURE


1. CHECK LOW BEAM HEADLIGHTS OPERATION
  1. Check that the low beam headlights operate normally (Click here).

    OK:
    Low beam headlights operates normally.



NG
GO TO LIGHTING SYSTEM (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (HEADLIGHT CLEANER CONTROL RELAY - MAIN BODY ECU)

  1. E247720E01
    Disconnect the E2 main body ECU (cowl side junction block LH) connector.

  1. Disconnect the headlight cleaner control relay connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (HDLO) - E2-13 (HDLO)
    Always
    Below 1 Ω
    1 (HDLO) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK MAIN BODY ECU (COWL SIDE JUNCTION BLOCK LH)

  1. E139345E22
    Disconnect the headlight cleaner control relay connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    1 (HDLO) - Body ground
    Engine switch on (IG)
    Headlight dimmer switch in HEAD
    11 to 14 V
    1 (HDLO) - Body ground
    Engine switch on (IG)
    Headlight dimmer switch not in HEAD
    Below 1 V



NG
REPLACE MAIN BODY ECU (COWL SIDE JUNCTION BLOCK LH)
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Washer Signal Circuit (from Jan 2012)Front Wiper Motor Circuit (Sep 2011 – Dec 2011) →