FAIL-SAFE CHART
System information · Vehicles built from Jan 2012
| Automatic Headlight Beam Level Control System (w/ Static Headlight Auto Leveling) |
The headlight leveling ECU operates in fail-safe mode if an abnormal condition such as those listed below has been detected.
Item
Abnormality Detection Condition
Return Condition
Warning Indicator
Height control sensor power source voltage
Abnormal height control sensor power source voltage (4.6 V or less, or 6.25 V or more) is detected.
Voltage of 4.61 to 6.24 V is detected
Illuminated
Height control sensor signal voltage
Abnormal height control sensor signal voltage (0.25 V or less, or 4.75 V or more) is detected.
Voltage of 0.26 to 4.74 V is detected
High power source voltage
Abnormal high power source voltage (18.5 V or more) is detected.
Voltage of 17.5 V or less is detected
Not illuminated
Low power source voltage
Abnormal low power source voltage (9.0 V or less) is detected.
Voltage of 9.3 V or more is detected
Not illuminated
Abnormal height control sensor signal while initialization
Initialization is performed outside the valid range of the voltage for initialization.
Initialization is successfully completed within the valid range of the voltage for initialization.
Illuminated
| Automatic Headlight Beam Level Control System (w/ Dynamic Headlight Auto Leveling) |
| Malfunctioning Part |
Detection Condition |
Fail-safe Control |
Warning Indicator |
| Speed Sensor |
Speed sensor signal malfunction |
Continues control. |
Illuminated |
| Rear Height Control Sensor LH (w/o Active Height Control Suspension) |
Rear height control sensor LH signal malfunction |
|
Illuminated |
| Source voltage malfunction | |||
| Height Control Sensor Signal (w/ Active Height Control Suspension) |
Height control sensor signal malfunction |
|
Illuminated |
| Headlight Leveling Motor |
Headlight leveling motor communication error |
Abnormal side headlight leveling motor:
|
Illuminated |
Headlight leveling motor malfunction
|
Abnormal side headlight leveling motor:
|
||
| Headlight Leveling Motor |
Voltage malfunction |
Abnormal side headlight leveling motor:
|
Not illuminated |
| CAN Communication System |
Vehicle specifications unconfirmed (Main body ECU) |
Continues control. |
Illuminated |
| Communication signal malfunction (Main body ECU) | |||
| Communication signal malfunction (Skid control ECU) |
Judges that the vehicle speed is 0 km/h (0 mph) and continues control. |
||
| Headlight Swivel ECU |
Vehicle specifications unconfirmed |
Continues control. |
Illuminated |
| Rear height control sensor LH initialization unconfirmed |
Both headlight leveling motors:
|
Blinks 6 times at 2 Hz after the ignition switch is turned from off to ON |