2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

GPS Mark is not Displayed

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

INSPECTION PROCEDURE


1. CHECK CABIN
  1. Check the cabin for any object that might interrupt radio reception on the instrument panel. If such an object exists, remove it and check if the GPS mark reappears.

    HINT:
    The GPS uses extremely faint radio waves originating from satellites. If the signal is interrupted by obstructions or other radio waves, the GPS may not be able to properly receive the signal.

    OK:
    The GPS mark appears.



NG
Go to step 2
OK

NORMAL OPERATION

2. CHECK SURROUNDINGS

  1. Check if the vehicle is in a location where GPS signal reception is poor. If the vehicle is in such a place, relocate the vehicle and check if the GPS mark reappears.

    HINT:
    The GPS uses 24 satellites in 6 orbits. At any point in time, 4 satellites should be able to pinpoint your vehicle. However, GPS signals may not reach the vehicle due to influence from the surroundings, vehicle direction and time. For examples, see the following illustration.

    I100196E07

    OK:
    The GPS mark is displayed.



NG
Go to step 3
OK

SYSTEM RETURNS TO NORMAL

3. CHECK GPS INFORMATION (OPERATION CHECK)

  1. E198960
    Enter the "GPS Information" screen. Refer to Check GPS & Vehicle Sensors in Operation Check (Click here).

  1. Check how many of the following codes appear in the "STS" column.

    OK:
    At least 3 codes appear.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

REPLACE DISPLAY AND NAVIGATION MODULE DISPLAY (Click here)


← Current Position Display does not Appear (Sep 2011 – Dec 2011)Voice Guidance does not Function (Sep 2011 – Dec 2011) →