2011-2013 Land Cruiser · Service Manual Brake

INSTALLATION

Removal / installation · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. INSTALL YAW RATE SENSOR
  1. Connect the sensor connector, and then attach the clamp to the hole of the sensor bracket.

    NOTICE:
    Securely connect the connector.

  1. Install the yaw rate sensor with the 2 bolts.

    Torque:
    15 N*m{ 148 kgf*cm , 11 ft.*lbf }

    NOTICE:
    1. Make sure that the sensor is oriented correctly.
    2. If the sensor is dropped, replace it.

    3. When installing the sensor, make sure to avoid impacts to the sensor.

      C177095E01

      C170924E01


2. INSTALL COOLING BOX ASSEMBLY (w/ Cool Box)
(Click here)

3. INSTALL REAR CONSOLE BOX SUB-ASSEMBLY (w/o Cool Box)
(Click here)

4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


5. PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION
  1. Perform the yaw rate sensor zero point calibration (Click here).


6. CHECK YAW RATE SENSOR SIGNAL
  1. Check the yaw rate sensor signal (Click here).

← INSTALLATION (Sep 2011 – Dec 2011)COMPONENTS (from Sep 2011) →