2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

P0617 Starter Relay Circuit High

Diagnostic trouble codes · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

While the engine is being cranked, the positive battery voltage is applied to terminal STA of the ECM. If the ECM detects the Starter Control (STA) signal while the vehicle is being driven, it determines that there is a malfunction in the STA circuit. The ECM then illuminates the MIL and stores the DTC.
This monitor runs when the vehicle is driven at 20 km/h (12.4 mph) for over 20 seconds.
DTC Code
DTC Detection Condition
Trouble Area
P0617
When conditions (a), (b) and (c) are met, and a positive (+B) battery voltage of 10.5 V or higher is applied to the ECM for 20 seconds (1 trip detection logic).
  1. (a) The vehicle speed is 20 km/h (12.4 mph) or more.
  2. (b) The engine speed is 1000 rpm or more.
  3. (c) The STA signal is ON.
  1. Park/Neutral Position (PNP) switch
  2. Starter relay circuit
  3. Engine switch
  4. ECM

WIRING DIAGRAM

A180644E17

INSPECTION PROCEDURE

HINT:
  1. The following troubleshooting flowchart is based on the premise that the engine is cranked normally.
    If the engine will not crank, proceed to the Problem Symptoms Table (Click here).
  2. Read freeze frame data using the intelligent tester. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.


1. READ VALUE USING INTELLIGENT TESTER (STARTER SIGNAL)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the engine switch on (IG) and turn the tester on.

  1. Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Starter Signal.

  1. Check the value displayed on the tester when the engine switch is turned to the START positions.

    OK:
    Engine Switch Position
    Starter Signal
    On (IG)
    OFF
    START
    ON



NG
Go to step 2
OK

CHECK FOR INTERMITTENT PROBLEMS (Click here)

2. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY
  1. Inspect the park/neutral position switch (Click here).



NG
REPLACE PARK/NEUTRAL POSITION SWITCH ASSEMBLY (Click here)
OK


3. CHECK HARNESS AND CONNECTOR (PNP SWITCH - ECM)
  1. Disconnect the C24 PNP switch connector.

  1. Disconnect the A38 ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    C24-5 - A38-46 (STA)
    Always
    Below 1 Ω
    C24-5 or A38-46 (STA) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

GO TO CRANKING HOLDING FUNCTION CIRCUIT (Click here)


← P0617 Starter Relay Circuit High (Sep 2011 – Dec 2011)P0657 Actuator Supply Voltage Circuit / Open (Sep 2011 – Dec 2011) →