P0657 Actuator Supply Voltage Circuit / Open
Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
The ECM monitors the output voltage to the throttle actuator. This self-check ensures that the ECM is functioning properly. The output voltage usually is 0 V when the engine switch is turned off. If the output voltage is higher than 7 V when the engine switch is turned off, the ECM will illuminate the MIL and store DTC(s) when the engine switch is turned on (IG).| DTC Code |
DTC Detection Condition |
Trouble Area |
| P0657 |
A throttle actuator power supply error. |
ECM |
INSPECTION PROCEDURE
| 1. CHECK DTC |
Clear DTC (Click here).
Turn the engine switch off.
Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the negative (-) battery terminal.
Turn the engine switch on (IG) for 10 seconds.
Turn the engine switch off.
Turn the engine switch on (IG).
Check DTC.
- OK:
- P0657 is not output.
|
|
||||
| OK | ||
| ||
