2011-2013 Land Cruiser · Service Manual Vehicle Interior

DATA LIST / ACTIVE TEST

System information · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


DATA LIST

HINT:
Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the tester on.

  4. Enter the following menus:
    Body / (desired system) / Data List.

  5. According to the display on the tester, read the Data List.

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    D Door Courtesy SW
    Driver side door courtesy light switch signal / ON or OFF
    ON: Driver side door opened
    OFF: Driver side door closed
    -
    D Door Lock Pos SW
    Driver side door lock position switch signal / ON or OFF
    ON: Driver side door unlocked
    OFF: Driver side door locked
    -
    Door Key SW-Lock
    Door key linked lock switch signal / ON or OFF
    ON: Driver side door key cylinder turned to lock position
    OFF: Driver side door key cylinder not turned
    -
    D-Door Key SW-UL
    Door key linked unlock switch signal / ON or OFF
    ON: Driver side door key cylinder turned to unlock position
    OFF: Driver side door key cylinder not turned
    -
    P-Door Courtesy SW
    Front passenger side door courtesy light switch signal / ON or OFF
    ON: Front passenger side door opened
    OFF: Front passenger side door closed
    -
    P-Door Lock Pos SW
    Front passenger side door lock position switch signal / ON or OFF
    ON: Front passenger side door unlocked
    OFF: Front passenger side door locked
    -
    RL Door Courtesy SW
    Rear LH side door courtesy light switch signal / ON or OFF
    ON: Rear LH side door opened
    OFF: Rear LH side door closed
    -
    RL-Door Lock Pos SW
    Rear LH side door lock position switch signal / ON or OFF
    ON: Rear LH side door unlocked
    OFF: Rear LH side door locked
    -
    RR Door Courtesy SW
    Rear RH side door courtesy light switch signal / ON or OFF
    ON: Rear RH side door opened
    OFF: Rear RH side door closed
    -
    RR-Door Lock Pos SW
    Rear RH side door lock position switch signal / ON or OFF
    ON: Rear RH side door unlocked
    OFF: Rear RH side door locked
    -
    Back Door Courtesy SW
    Back door courtesy light switch signal / ON or OFF
    ON: Back door open
    OFF: Back door closed
    -
    Back Door Open Handle SW
    Back door opener handle switch signal / ON or OFF
    ON: Back door opener switch pushed
    OFF: Back door opener switch not pushed
    -
    Back Door Lock Pos SW
    Back door lock position switch signal / ON or OFF
    ON: Back door unlocked
    OFF: Back door locked
    -
    Back Door Open
    Back door open status / Permit or Prohibit
    Permit: Back door unlocked
    Prohibit: Back door locked
    -
    IG SW
    Ignition switch status / ON or OFF
    ON: Ignition switch ON
    OFF: Ignition switch off
    -
    ACC SW
    Ignition switch status / ON or OFF
    ON: Ignition switch ACC
    OFF: Ignition switch off
    -
    Communication Double Locking
    Connection status between double door lock ECU and main body ECU / OK or STOP
    OK: Connection
    STOP: No connection
    -
    Communication Master SW
    Connection status between master switch and main body ECU / OK or STOP
    OK: Connection
    STOP: No connection
    -
    Master Switch 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Door Lock Switch Status
    Door manual lock switch signal / ON or OFF
    ON: Door control switch ON (LOCK)
    OFF: Door control switch OFF
    -
    Door Unlock Switch Status
    Door manual unlock switch signal / ON or OFF
    ON: Door control switch ON (UNLOCK)
    OFF: Door control switch OFF
    -


ACTIVE TEST

HINT:
Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the tester on.

  4. Enter the following menus:
    Body / Main Body / Active Test.

  5. According to the display on the tester, perform the Active Test.

    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Door Lock
    Operate door lock motor
    Lock or Unlock
    -
    D-Door Unlock
    Operate door lock motor
    ON or OFF
    -
    Trunk and Back-Door Open
    Operate back door opener
    ON or OFF
    -

← TERMINALS OF ECU (from Sep 2011)DATA LIST / ACTIVE TEST (from Jan 2012) →