2011-2013 Land Cruiser · Service Manual Vehicle Interior

Engine Hood Courtesy Switch Circuit

Circuit diagnosis · Vehicles built from Sep 2011

DESCRIPTION

  1. The engine hood courtesy switch is built into the hood lock. This switch turns on when the engine hood is opened and turns off when the engine hood is closed.

WIRING DIAGRAM

B294199E01

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER (ENGINE HOOD COURTESY SWITCH)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Body / Main Body / Data List.

  1. Read the Data List according to the display on the intelligent tester.

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Hood Courtesy Switch
    Engine hood courtesy switch /
    ON or OFF
    ON: Engine hood open
    OFF: Engine hood closed
    -

    OK:
    ON (engine hood is open) appears on screen.



NG
Go to step 2
OK

REPLACE MAIN BODY ECU (COWL SIDE JUNCTION BLOCK ASSEMBLY LH)

2. INSPECT HOOD LOCK ASSEMBLY (ENGINE HOOD COURTESY SWITCH)

  1. for LHD:B219990E03

    Text in Illustration 
    *a
    Unlock Position
    *b
    Lock Position
    1. Remove the hood lock (Click here).

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      Unlock position
      10 kΩ or higher
      1 - 2
      Lock position
      Below 1 Ω

  1. for RHD:B219989E03

    Text in Illustration 
    *a
    Unlock Position
    *b
    Lock Position
    1. Remove the hood lock (Click here).

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      Unlock position
      10 kΩ or higher
      1 - 2
      Lock position
      Below 1 Ω



NG
REPLACE HOOD LOCK ASSEMBLY (ENGINE HOOD COURTESY SWITCH)
OK


3. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - HOOD LOCK AND BODY GROUND)
  1. Disconnect the E30 main body ECU connector.

  1. Disconnect the E1 hood courtesy switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E1-16 (HCTY) - A8-2
    Always
    Below 1 Ω
    A8-1 - Body ground
    Always
    Below 1 Ω
    E1-16 (HCTY) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU (COWL SIDE JUNCTION BLOCK ASSEMBLY LH)


← DATA LIST / ACTIVE TEST (from Sep 2011)Security Horn Circuit (from Sep 2011) →