2011-2013 Land Cruiser · Service Manual Vehicle Interior

Security Indicator Light Circuit

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

  1. When the theft deterrent system is in the disarmed state, the security indicator will flash continuously if the immobiliser system is set, or not illuminate if the immobiliser system is not set.
    When the theft deterrent system is in the armed state, the immobiliser system is automatically set and the security indicator will flash continuously.
    When the theft deterrent system is in the arming preparation state or alarm sounding state, the main body ECU (cowl side junction block assembly LH) causes the security indicator to be illuminated.

WIRING DIAGRAM

B184353E19

INSPECTION PROCEDURE


1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (SECURITY INDICATOR)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Body / Main Body / Active Test.

  1. According to the display on the intelligent tester, perform the Active Test.

    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Security Indicator
    Security indicator
    ON / OFF
    -

    OK:
    Security indicator illuminates.



NG
Go to step 2
OK

REPLACE MAIN BODY ECU (COWL SIDE JUNCTION BLOCK ASSEMBLY LH)

2. CHECK HARNESS AND CONNECTOR (CLOCK - MAIN BODY ECU AND BODY GROUND)
  1. Disconnect the g1 clock assembly connector.

  1. Disconnect the E4 main body ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    g1-9 (LP) - E4-4 (IND)
    Always
    Below 1 Ω
    g1-1 (E) - Body ground
    Always
    Below 1 Ω
    g1-9 (LP) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. REPLACE CLOCK ASSEMBLY (SECURITY INDICATOR LIGHT)
  1. Temporarily replace the clock assembly (security indicator light) with a new or normally functioning one (Click here).

  1. When the theft deterrent system is in the arming preparation state, check that the security indicator light is illuminated.

    OK:
    Security indicator light is illuminated.



NG
REPLACE MAIN BODY ECU (COWL SIDE JUNCTION BLOCK ASSEMBLY LH)
OK

END (CLOCK ASSEMBLY WAS DEFECTIVE)


← Security Horn Circuit (from Sep 2011)Security Indicator Light Circuit (from Jan 2012) →