2011-2013 Land Cruiser · Service Manual Vehicle Exterior

INSTALLATION

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.


1. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY

B180573E01
  1. Attach the claw and Install the mirror with the 3 nuts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. w/ Power Mirror Control System:

    1. Attach the clamp.

    2. Connect the connector labeled A.


2. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY
  1. Connect the connector.

  1. B183139
    Connect the front door lock remote control cable and front door inside locking cable to the front door inside handle sub-assembly.

  1. B180821
    Attach the 4 claws and 13 clips to install the front door trim board sub-assembly.

  1. Install the 3 screws.


3. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH

  1. B180820
    Detach the clip and claw, remove the front lower door frame bracket garnish.


4. INSTALL DOOR ASSIST GRIP COVER

  1. B180819
    Using a moulding remover, detach the 8 claws and remove the door assist grip cover.


5. INSTALL FRONT DOOR ARMREST BASE PANEL ASSEMBLY
  1. Connect the connector.

  1. B183137
    Attach the 5 claws to install the armrest base panel.


6. INSTALL FRONT DOOR INSIDE HANDLE BEZEL

  1. B183136
    Attach the 4 claws to install the bezel.


7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
← REASSEMBLY (from Jan 2012)INSTALLATION (from Jan 2012) →