B2000 Short to B+ in Seat Belt Motor RH Circuit
Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011
Also covers:
- B2005 Short to B+ in Seat Belt Motor LH Circuit
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
The seat belt control ECU receives information from the master cylinder solenoid (skid control ECU) via the CAN communication line and tightens the seat belt by operating the motor in the front seat outer belt assembly RH or LH.| DTC Code |
DTC Detection Condition |
Trouble Area |
| B2000 |
|
|
| B2005 |
|
|
WIRING DIAGRAM




INSPECTION PROCEDURE
- CAUTION:
- The pretensioner is built into the front seat outer belt assembly. Be sure to follow the correct inspection procedure, as failure to follow the correct procedure (such as inspection of incorrect connectors) may deploy the pretensioner.
| 1. CHECK SEAT BELT CONTROL ECU |
Disconnect the E41 seat belt control ECU connector.

Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
for LH Tester Connection
Switch Condition
Specified Condition
E41-3 (MOL+) - Body ground
Ignition switch ON
Below 1 V
E41-4 (MOL-) - Body ground
for RH Tester Connection
Switch Condition
Specified Condition
E41-1 (MOR-) - Body ground
Ignition switch ON
Below 1 V
E41-2 (MOR+) - Body ground
Result Result
Proceed to
OK
(for LHD)
A
OK
(for RHD)
B
NG
C
|
|
||||
|
|
||||
| A | ||
| ||
| 2. CHECK HARNESS AND CONNECTOR (FRONT SEAT OUTER BELT - SEAT BELT CONTROL ECU) |
Disconnect the E41 seat belt control ECU connector.

Disconnect the K11*1 or L5*2 front seat outer belt connector.
- HINT:
- *1: for LH
- *2: for RH
- *1: for LH
Measure the voltage according to the value(s) in the table below.
- Standard Voltage :
for LH Tester Connection
Switch Condition
Specified Condition
K11-1 (MOL+) - Body ground
Ignition switch ON
Below 1 V
K11-2 (MOL-) - Body ground
for RH Tester Connection
Switch Condition
Specified Condition
L5-1 (MOR+) - Body ground
Ignition switch ON
Below 1 V
L5-2 (MOR-) - Body ground
Result Result
Proceed to
OK
(for DTC B2000)
A
OK
(for DTC B2005)
B
NG
C
|
|
||||
|
|
||||
| A | ||
| ||
