2011-2013 Land Cruiser · Service Manual Vehicle Interior

B2060 ABS Malfunction

Diagnostic trouble codes · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

This DTC is stored when a malfunction in the vehicle stability control system is detected. This circuit consists of the master cylinder solenoid (skid control ECU) and seat belt control ECU. Signals are sent from the master cylinder solenoid (skid control ECU) via the CAN communication line.
DTC Code
DTC Detection Condition
Trouble Area
B2060
Malfunction in the brake system is detected.
  1. CAN communication system
  2. Vehicle stability control system
  3. Seat belt control ECU

WIRING DIAGRAM

E149011E02

INSPECTION PROCEDURE


1. CHECK DTC (CAN COMMUNICATION SYSTEM)
  1. Use the intelligent tester to check if the CAN communication system is functioning normally (Click here for LHD, Click here for RHD).

    Result 
    Result
    Proceed to
    OK
    (DTC U0122 is not output)
    A
    NG
    (for LHD)
    B
    NG
    (for RHD)
    C

    HINT:
    DTC U0122: Lost Communication with Skid Control ECU



B
GO TO CAN COMMUNICATION SYSTEM (Click here)

C
GO TO CAN COMMUNICATION SYSTEM (Click here)
A


2. CHECK DTC (VEHICLE STABILITY CONTROL SYSTEM)
  1. Using the intelligent tester, enter the following menus: Chassis / ABS/VSC/TRAC / Trouble Code.

  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    OK:
    DTC is not output.



NG
GO TO VEHICLE STABILITY CONTROL SYSTEM (DTC CHART) (Click here)
OK


3. CHECK DTC (PRE-CRASH SAFETY SYSTEM)
  1. Using the intelligent tester, enter the following menus: Body / Pre-Crash / Trouble Code.

  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    Result 
    Result
    Proceed to
    OK
    (DTC B2060 is not output)
    A
    NG
    (for LHD)
    B
    NG
    (for RHD)
    C



B
REPLACE SEAT BELT CONTROL ECU (Click here)

C
REPLACE SEAT BELT CONTROL ECU (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)


← B2060 ABS Malfunction (Sep 2011 – Dec 2011)B2070 VSC Buzzer (Sep 2011 – Dec 2011) →