2011-2013 Land Cruiser · Service Manual Vehicle Interior

B2070 VSC Buzzer

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

When the master cylinder solenoid (skid control ECU) detects a malfunction in the VSC warning buzzer circuit, a malfunction signal is sent to the seat belt control ECU, and this DTC is stored.
DTC Code
DTC Detection Condition
Trouble Area
B2070
While the ignition switch is ON, the skid control ECU buzzer circuit malfunction signal is received by the seat belt control ECU.
  1. Vehicle stability control system
  2. Seat belt control ECU

INSPECTION PROCEDURE


1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (BUZZER)
  1. Using the intelligent tester, enter the following menus: Chassis / ABS/VSC/TRAC / Active Test.

    ABS/VSC/TRAC 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Buzzer
    Skid control buzzer sounds
    OFF or ON
    -

    OK:
    Skid control buzzer sounds.

    Result 
    Result
    Proceed to
    OK
    (for LHD)
    A
    OK
    (for RHD)
    B
    NG
    C



B
REPLACE SEAT BELT CONTROL ECU (Click here)

C
GO TO VEHICLE STABILITY CONTROL SYSTEM (Skid Control Buzzer Circuit) (Click here)
A

REPLACE SEAT BELT CONTROL ECU (Click here)


← B2060 ABS Malfunction (from Jan 2012)B2070 VSC Buzzer (from Jan 2012) →